Wireless

Hi,I need to design a solution for a residential colony. The solution should provide indoor wireless coverage to the users inside homes. There is no other cabling infrastructure available in the colony and I was considering to deploy Cisco 1522 Mesh ...

I have 4402(50) with 25 nos. 1242 LWAP, I have two guest wlan (guest1 & guest2) with different dynamic interface and vlan. both dhcp scopes assigned in wlc mgmt. guest1 wlan is working properly, guest2 is not authenticating with web authentication. ...

I have some demo gear that I am trying to get going for a POC and having one heck of a time working. The AP's and WLAN controller are on the same subnet and vlan as well as the dhcp server. I have a trunk going to port 1 on the controller and I have ...

How do you connect ACS LEAP-FAST to 4404? I'm wanted to have an open SSID where the students can login with their Novell Usernames/passwords but get encrypted.

I know this is going to be somewhat biased, but I have the unique opportunity to choose a wireless NIC for our company.It's like this... We have been rolling out many different types of laptops from Dell over the last couple of years and each one ha...

I i want to upgrade from à version 4.1.83.0 to à version 4.2.110.0 can you tell me if the step are : stop the server, backup the data base with dbadmin abd install the new version and restore the database.

Location 2700 - 3.1.42.0 WCS - 4.2.81.0WLC - 4402 - 5.1.151.0I recently added a 2nd controller into my wireless infrastructure and I cant seem to get the location device to locate clients. It works no problem with the 1st controller.The time on the d...

I cannot seem to get this darn AiroNet 1130AG AP to allow 'b' devices. All of the examples I have found are not the same GUI interface as what this one has. I just upgraded the IOS to the lastest as of 5/6/2009. How do I get this to work.

Getting the following error:ap(config)#int dot11Radio 0ap(config-if)#ssid Wirelessap(config-if)#ap(config-if)#no shut*Mar 1 00:05:52.598: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset*Mar 1 00:05:52.902: %DOT11-2-NO_FIRMWARE: Inter...

Hello,We are utilizing Cisco aironet 1200 waps, currently the management interfaces are located on the public network, a big no no, we don't currently have Nat and aren't looking to enable nat for a while. I was trying to think of a way to put the ma...

I try to get an IP address for the interface this card generates (interface Cellular 0/3/0) I already did basic configuration for it but nothing happens. Doing "show ip interface brief" the interface is up in status and up in protocol and doing "show...

Hello,we have a big issue with our WLCs.We want to secure our wireless networks with a checkpoint firewall in front.Because of high availability we have two firewalls.If the active firewall breaks the backup firewall sends a gratuitous arp to tell al...

Is there any way to run Location Appliance (2710) software on a virtual machine with a trial license for testing and/or educational purposes?

Quick question (I hope): I'm installing WCS for the first time on a VMWare server. The server and Vmachine all meet the requirements outlined in the WCS documentation, however I'm unsure which version of WCS I should start with.4.2.111.0 MD is show...