Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Can 1310 be deployed in bridge mode (point-to-multipoint) with several 1241AG(which are in workgroup bridge mode)??? All APs are autonomous.With what APs is 1310 compatible as a bridge-to-bridge?

kostica by Level 1
  • 614 Views
  • 1 replies
  • 0 Helpful votes

Hi everyone - hope someone knows the answer to my following question. I simply need to know what is signal and what exactely is noise. Signal:I guess the "signal" value, is the signal strength of the 802.11 traffic. right?Noise:From my understanding,...

Is it possible to deploy TACACS on a VxWorks wireless AP?If so, how? Is there a link to such a configuration?I found a Cisco link to configuring the AP in its entirety, but I dont see anything about TACACS.ThanksVictor

lamav by Level 8
  • 637 Views
  • 4 replies
  • 0 Helpful votes

For those of us that are familiar with the process by which an AP finds its controller, we know that there is L2 broadcast, Option 43, DNS resolution, and shared neighbor information via OTP, as well as the final option to statically assign a control...

Is there away to get the packets from the client out of LWAPP? I can sniff the traffic or all I get is encrypted info. I'd like to take a look at my clients traffic to see if QoS is tagging properly for some voice issues in regards to vocera. Thanks

Resolved! WLC

I'm not sure really how to ask this, but I have done some testing in a classroom on my college campus using a wired connection and then a wireless connection. When connected wirelessly, I can see other devices in the network. When connected through...

waldronks by Level 1
  • 601 Views
  • 4 replies
  • 0 Helpful votes

---Error Log in WLC---*Feb 25 09:06:49.014: %LWAPP-3-RD_ERR4: spam_lrad.c:2040 Invalid regulatory domain 802.11bg:-ACE 802.11a:-C for AP 00:21:d8:48:5a:94*Feb 25 09:06:49.014: %LWAPP-3-RD_ERR7: spam_lrad.c:8048 Invalid country code () for AP 00:21:...

We just got a T1 line installed for a remote location...What would be a good wireless router to get. They are going to WEBVPN into our main building. But i need a wireless router to support T1 speeds, since we are paying for it...Any help would be ap...

I had this occur on two 4402's in 1 week. Unexpected system reload based on uptime although no crash log, controller will not associate any NEW clients, existing clients OK, controller reports erroneous client count. Then after rebooting the contro...

I'm installing a Cisco AP with a power injector. I'm trying to figure out how to find out the mac address of the switch port the AP will be connected to? I've read over several posts here that all talk about solving my problem by setting the power se...

rjrii by Level 1
  • 6525 Views
  • 3 replies
  • 0 Helpful votes

hi everybody,i have the next proble, i hope someone can help meActually I wrok with a 1522 Mesh Network,1130 LWAPP and Bridge 1400 point to point. 1522 and 1130 are asociated with WLC.I have a WLC4402 (4.1.192.22M (Mesh)image) this wlc is conected vi...

Review Cisco Networking for a $25 gift card