Wireless

Trying to add an autonomous 1231 AP to WCS in preparation for conversion to LWAPP doesn't even start and produces "Failed to add device to WCS Reason: Could not execute JDBC batch update" IOS is 12.3(7)JA5WCS 6.0.132.0+Anybody run into this?  Simple ...

Hi,I have a specific requirement to bind MAC address of a particular user to the username (Using EAP-FAST with ACS 4.2). The user should be authenticated only if he is using the particular client adapter (MAC address) with correct username.I have one...

Hello all,In a Cisco 4404 WLAN controller, why do the 802.11b clients get stuck in probing instead of associated?  (802.11g works fine).  I've tried the following:1. Disabled/enabled all b/g radios2. set 11mpbs rate to supported instead of mandatoryB...

Hello,I have been using a CIsco WLC 4400 the past year.  The version is 4.2.173.0.  Over the past month I have started to block equipment I do not want on the wireless network by MAC address in teh disabled clients list.  So far I have 201 devices.  ...

Hi,I have a Cisco Access Point 1131 series  in autonomus mode whit a SSID whit WPA, the users are connected sucessfull to the Wireless but the problem is that phone calls using the Cisco IP Communicator, are heard in one way. Which could be the probl...

Hello,I would like to ask you a question related to the WCS, I have the version 5.2.130 ..I wonder if it is possible that when I look for a client that is associated to some WLC, selecting the client, I get four tabs General, Statics, Location and Hi...

Hi,Instead of statically assigning a vlan to a switch port where the AP is connected, is there a way to use 802.1x or NAC to assign the right vlan to an AP itself (not the clients)?

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in ...

Hello GuysI have a very basic questionThere is 66 KV power line going across the land where i want to set up a wirless and RF id based solution. Do this power linecause any interference for the communicationThanksHarish

HI,We have a wireless infrastcucture and have many clients using it with no issues. Our lease is 12 hours on the guest wireless and laptops work fine. We have complaits that PDAs or iPhones lose connectivity regularly (probably every 1 or 2 hours). I...

Hello,I would like to ask you a question related to the WCS, I have the version 5.2.130 ..I wonder if it is possible that when I look for a client that is associated to some WLC, selecting the client, I get four tabs General, Statics, Location and Hi...