Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I was thrown onto this hospital project and was only expecting it to take a week. Please take a look at some of these jpegs and give me your opinion on the placement and # of AP's.This hopital wants coverage for data/voice. They will be installing ...

zmann7 by Level 1
  • 769 Views
  • 3 replies
  • 0 Helpful votes

Just wondering if there is a maximum number of users per WLAN ? We have around 60 sites and are considering having 2 to 4 WLAN's for users with a /21 subnet and wondered if this should be broken up into multiple WLAN's on a /24 subnet or will this be...

bramsay by Level 1
  • 470 Views
  • 1 replies
  • 0 Helpful votes

Hello,I need help with a 1200 series Aironet. When doing a SH IP INT BRIEF it is showing RESET on the Dot1Radio0 interface.Dot11Radio0 Status reset What does this mean? and how to I initiate this interface? is it because I do not have...

Hello,I have a situation where I am trying to locate a rogue AP in one of my office buildings. When I bring a laptop over there with NetStumbler or Inssider, I get no response from any access points or clients. Its like that throughout the entire bui...

We have Symbol Pocket PC's that support WPA, but NOT WPA2. Can I implement WPA on my Cisco Aironet 1200 series AP's? The model number on my AP's are: AIR-AP1231G-A-K9I need to do WPA-personal (PSK, i think), not WPA-enterprise.Any help would be gre...

tpersio by Level 1
  • 1485 Views
  • 4 replies
  • 0 Helpful votes

Is there any way to set the RRM parameters such as max power or channel selection for AP's. I would like to have the network set their own settings but would like to set a max power for the AP's

jcosgrove by Level 1
  • 563 Views
  • 2 replies
  • 0 Helpful votes

Doing a search on Google to find the purpose of the Order bit in the 802.11 header (subfield of the frame control field) only provides a generic (not helpful) explanation of how it's used for stict ordering of the fragments/frames. Fine, but what doe...

bmbreer by Level 1
  • 1482 Views
  • 2 replies
  • 0 Helpful votes

Hi.Anyone got the attached screen? I am not able to setup a simple root and non-root link and suspect from faulty hw. I would appreciate any sample config to test the link. I tryed with config from othe two same APs but not working (old used 12.3 a...

We have a number of autonomous 1200 series APs running 12.3(8)JEA1 IOS. What I want to know is how, or can I, monitor the number of users and the data rates being used on each AP w/out a controller? We have Cacti and were curious if this informatio...

Review Cisco Networking for a $25 gift card