Wireless

Hi,I need to know what is the function of the option "External Configuration Option". In all the cases I do not enable this option and I do not have problems. regards,

I am looking for documents about using wifi in highly reflective enviroments: rooms with aluminium floor, walls and ceiling en very little materials that absorb rf. (cleanroom enviroment) Any hints are appreciated.

Hi,We have a customer link for a distance of 10 kms outdoor installation, for the past two days the link is slow, suspect antenna alingment and asked the customer to observe ,attached is the link status can you suggest for better performance.

Folks, Can Location server be installed on anyserver or does it have to be installed on the appliance. I was to demo it to a customer of mine and wanted to see if i could install it on a linux box?Thanks

Hi Netpro,does anyone know about the Cisco Appliance server 1113 can generate the Certificate Signing Request ? how to make this working with Verisign server ?your reply will be highly appreciated.thanks a lot.

Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:"Band Select and Load Balancing CLI CommandsThe config band-select and config wlan band-select CLI commands appear in controller softwarerelease...

I have a Point to Mulitpoint connection. On top of a tower i have an cisco 1410 bridge with an omni antenna. I have 3 other sites that are currently connected to the omni from about 1,2, and 6km away. I am adding 2 more sites that are 8 and 9 km away...

Hello , I have a message error in the WCS (you can see the file attached )Keepalive message are lost. Can you help me for this question. best rtegards

We are in the process of buying the Wireless LAN controller 5500 series. The documenation that I saw with cisco was that it has only one ISP provider shared by corporate and guest. What we would like to do is have two ISP provider one for corporate u...

I cannot upgrade our WLC 4402 from version 5.0.148.0 to a higher version.I have read all the relevant documentation and upgrades for other 4402s and 2100s have worked.When I upgrade to 5.2.157.0, for example, the uplink port is disabled and I get the...

Hi,I need use external web authentication in my WLAN. I configured it in WLC, the redirect to web server is work fine and I can open the custom page of web server. The problem is that I don't know how back the credentials to WLC. The cisco's document...

i'd like to know on how many number of users can a 1130 AP support (i know by default the threshold is set to 12) if i have 24 users connected connected to 1 AP, will the users experience poor signal and experience connectivity issues? what is the be...

I have a guest wireless wlan setup. When guest users attach to our guest wireless they are prompted by the built in web security on the WLC's. Cisco talks about how to setup the WLC to route web authentication to an external web server, but they don'...

Hi all - setting up NAC guest Server.I want to pull the sponsor users in from active directory group. I have set up to connect to a domain controller with success (test successful) and then added the domain controller but when clicking on the active ...

I need to set up MAC authentication for a bunch of systems. I'd like to import the data from a file as there are quite a few of them, but I can't seem to get the format correct for the import file.Is this documented somewhere? Or does anyone know wha...