Wireless

I was looking in to upgrading a wlc526 and saw that there are only ED releases availible. Checked the documentation and there should be more releases then the ones that are published.I cant upgrade without upgrading to one of the versions that are no...

Hi,I'm very new to configuring wap.I want to configure multiple vlans on my wireless device 1242 AG.When i configure the AP with vlans, i don't reveice the SSID anymore, when configuring back to old config, everything working normal.The situation is ...

Has anyone taken the new CCIE wireless BETA exam? Did anyone else find that they only had 2hrs to complete the exam which simply wasn't long enough.You take on the exam would be appreciated.

Hello Friends, We recently installed 2 4402 WLCs. I configured Mobility group and split the APs between 2 WLCs by configuring Primary Controller on each AP. No secondary or tertiary Controller was configured.Now when WLC1 goes down, the APs on WLC1 r...

I have a 1242AP that I believe is in autonomous mode(the controller doesn't see it but the AP can ping the controller) but I can't upgrade the IOS on the AP. I can ping the AP from my laptop but I can't open the GUI. Is it possible to upgrade the IOS...

Hi All,I have just converted my unit of AP1200 to LWAPP by only copy c1200-rcvk9w8-mx into the AP and set AP to boot from this image. After which, I try have the AP associate the WLC. But it fails and keep reooting. Is there anyway to stop the AP fro...

WCS 5.1. I can't find any way to download a sample.tar file from the WCS for a passthrough template, only for a webauth (username+password) template. Is it in there and I'm just blind? Or is there anyplace else I can find a tar bundle template for a ...

HiI am using subject mentioned APs(Fat).I have two distances(almost 40 meter and 90 meter) to be covered.There is no possibility to reach through cables either by Cat or Fiber.Is there is APs mode we can configure Bridge or .. that can cover above me...

Hi,As I can only use 3 channels in 1 cell what happens if I have more than 30 users in this cell? So if I add another access point on say channel 4 it will interfere with channel 1 and channel 6.So what can I do? apart from using 802.11a ? Also at ho...

Hi,After replacing D-Link outdoor AP with LAP1522AG (3 AIR-ANT2450V-N type antennas)there is no stable wireless connection at the corner of the house opposite to AP because of the weak signal. AP is connected to 220 V AC. Current Tx Power Level - 1, ...

Hi, I'm trying to add my autonomous access points to WCS which I have done but I'm not getting any performance data or errors etc. Does anyone know if WCS support autonomous access points or do I have to use WLSE to get this infoThanks

(This appears to be the converse situation of another relatively recent post. I thought it might be better to have a separate thread rather than muddy up that conversation).I have a relatively new deployment of 8 WiSMs controllers (4 of which are cur...

Hi,What bandwith is possible between one AP 1250 (workgroup-bridge and Access-Point)with the 802.1n standart?regardsPascal

Hi,we use a WLC4402 with LWAPPs and different VLANs and SSIDs. I've configured a Linksys WET200 to associate to one of the SSIDs.On the WLC I can see, that the WET200 is associated. But with the connected PC to the WET200 (static IP) I can't ping any...

How does this work?I enabled HREAP to make wifi phones get the same network IP as the regualar Desk phone. But...the IP does not change if there is a overlap signal.