From the CLI how can I look at the number of APs connected to it?I think its (Cisco Controller) show>known ap summaryMAC Address State # APs # Clients Last Heard----------------- ------------------ ----- --------- ---------------...
I am troubleshooting a wireless network. On some spots, the signal strengths keep changing between -58dbm and -72dbm. Nobody moving around when I collected the data. I am WirelessMon running on a HP laptop with internal antenna. Is it normal? please...
Hello, I am having a problem with my Aironet 1200 not booting up. It was previously starting up ok, but I was having problems access it through web browser and so I reset it using the mode button and plugging in power. Ther Aironet now starts up to t...
I am currenlty having difficulty with random access points disassociating with their contollers. All this is viewed from the WCS. Current Version of the access points are 12.4(3g)JA2, Software Version on the controllers is 4.1.185.0I have upgraded t...
We are having difficulty connecting new AP's to our environment. We had a consultant who is no longer available help us setup our environment. He used a text file to upload into the AP's when setting them up so they would work in our environment. ...
Hi,The WLC v4.1 Config Guide says,"all Layer 2 wired communications betweencontrollers and lightweight access points are secured by passing data through LWAPP tunnels."Is it correct that this is only true for the LWAPP Control channel which is encryp...
General consensus please.I would like to know the limitations and/or differences between the 1130 and 1240 ap?s.We are replacing our wireless infrastructure and plan on using 1130 series ap?s. before we pull the trigger, we just want to know any and ...
We're getting an error when we try to use the GUI to add and remove MAC addresses from a our ACL for filtering purposes. Cisco's doc says that we need to delete or clear the existing ACL using the CLI in order for us to get rid of the error message ...
Currently we are running some scan guns on the floor, a new model is running with no issue and the MAC doesn't show up in the logs.For the older scan guns I am seeing the following messages in the WLC 4402 logs:Fri Nov 2 08:13:04 2007 [SECURITY] 1x...
Am I right to assume that if you use LWAPP layer 2 between the APs and the WLC, that it wont work over a layer 3 boundary? LWAPP layer 2 uses ethernet frames, not ip packets, to communicate between the AP and the WLC. Is there anyway to get around ...
Hello,We need to upgrade our WLSE to WCS but our sales people bought the wrong license (WCS-Standard-K9) Is it possible to upgrade the WLSE to WCS with this license and just get the conversion CDs needed from you ?
I have a 150 ft Outdoor Ethernet Cable (AIR-ETH1500-150=) for the Mesh Radios and I would like to know if I can cut the cable to make it shorter and reterminate the RJ45 end. Does it require a special type of RJ45 connector?
Is there any way to figure out if a MAC address takeover has happened on one of your access points? Something similar to checking on a switch if the same IP/MAC pair is broadcasted on two separate ports.Thanks,Octavian
