Wireless

Hi all ,My WLC 4402 is running a version of 5.1.151.0 , my ACS is version 3.2. I have 1 AP connected properly to WLC and working with no problems. I configured everything just as is written in the WLC documentation to use RADIUS authentication by MAC...

I have the access point 521 express access point with LWAPP, and would like upgrade from Lightweight Mode to Autonomous ? I can do this in this model?

Good Day,I am trying to upgrade an AP-1252 from autonomous to LWAPP. I downloaded file c1250-rcvk9w8-tar.124-10b.JA3 but the upgrade tool rejects it claiming that the image is not a valid one.Should I be using a different file. Is there some other wa...

Anyone tried web authetication with proxy server.

We are trying to setup the four ports on our 4404 wireless lan controller to use LAG connected to a 3560G switch. If we connect distribution port 1 to a switch trunked port the unit works as expected. However, if we create an etherchannel containing ...

We are using the internal customized web frontend. We do have a VeriSign cert (.pem) loaded pointing to our virtual interface. For the most part this works in IE but only if you do the custom updates and get the Certificate updates. We are getting us...

Is there any list of wireless network cards that support 802.11 response packet including status code 17 needed for aggressive load-balancing to work?

Dearsi have forget username and password for wcs.can in break this or any solution for this ?RegardAsif

In the WCS under Managment - WEB Admin Ive turned WEB Mode to disable and secure web mode to enable, but can still http to log in page, log in then get redirected to HTTPS.It should drop the HTTP request has anyone come accross this issue.

HiI have WLC which is having 70 accesspoint associated with it.The model num of accesspoint is 1242.But if any one from outside bring one same model of accesspoint and tried to connect it should not connect.Did any one knows how to configure the cont...

After installing a new version of the ACU software my built-in 350 mini-PCI has stopped working. It appears that the card has gotten erased. When it is enabled Windows does not behave properly. When I try to manually load new firmware into the card i...

Does the lap have a command line? Like a stripped down version?I keep seeing cli stuff on cisco's website with it, but i can't telnet to any of my laps

Greetings,I have a tac case open on this issue but wanted to see if any of you may have encountered this problem.Our guest controller loses is connection path every 5 days for 10 or fifteen minutes and then works fine for another five days until it d...