Wireless

Hello!I need to set rate-limit for some mac addresses on access point aironet 1231.Is it possible?If no, what ios or devices can do it?Thanks.

I have a Cisco 1841 router with SDM. The router is functioning fine. Users can get to and from the Internet with no problem. We have a group of five engineers who periodically need to VPN to this site. The problem is that the VPN stops working and we...

We have a Cisco Wireless network using a variety of Cisco Access Points (1231G, 1120B, 1121G, Light Weight 1010). We are using 3Com wireless bridges to connect or older printers to the wireless network. I upgraded the 3com devices to firmware 2.1.7 s...

I have a WLC 2106 with 4 lightweight WAPs directly connected to it. The 2106 has an 802.1q trunk to a layer 3 device. The WAPs are registered and work fine; however, although I can 'ping' the controller from the layer 3 device I can't ping any of the...

How do I do this?I've tried the clear lwapp commands, and nothing seems to help.Do I need to load a new IOS?

I am wanting to troubleshoot the last week's log on a AP, but it only shows 12 hours. What is the config I need to run to save the logs from the last restart to a file on a server?Thanks for any info.

Hi All,Please help me on this issue:-I am currently running 3.0 version on my WLC 4402 and i want to upgrade it to the latest versions. I am following the correct procedure mentioned in the cisco link but its failing.The error is TFTP Path is getting...

Hi,I am trying to connect a:WS-G5484= 1000BASE-SX Short Wavelength GBIC (Multimode only)with aGLC-SX-MM= GE SFP, LC connector SX transceiverbut I can't find an appropriate cable since both these transceivers have different connectors. Your help is ap...

Hi,I need to fwd logs to MARS. I can forward syslogs from the wlc, but not the wcs. But in the syslog it seems that there is only the option to select one log type at a time. is there a way to get multiple log levels setup at once?

Hi Guys,Please help, can I have vlan on my wlan with catalyst 1912-A Enterprise Edition ?I read somewhere " The Cisco 1900 series does not support 802.1q, leaving ISL as the only option for creating trunk connections with other Cisco."RegardsSaher

I have many lightweight APs 1231 and I want to install a WLC in the network. My APs may be lightweight. How can I convert this APs to LWAP?Thanks.

we have a 1240 access point on our speed test we are getting only about 13MB when we should get around 30MB my vendor is telling me thats becuase the radio only works on half duplex is that correct??

Is it posible to create a point to multipoint wireless bridge where remote location are on different networks.Currently I have a wireless bridge for one customer (ssid a), now I need to add another customer to the root. I think to make trunk (2 vlans...