I am trying to monitor the number of clients connected to AP via snmp.I see two mib oids in AIRESPACE-WIRELESS-MIB that appear to give somewhat similar info.bsnApIfNoOfUsers (.1.3.6.1.4.1.14179.2.2.2.1.15) - No of Users associated with this rad...
Forum Posts
Hi,I am having an issue,My APs cannot join the controller when they are on NAT, meaning that they are on the same router but different subnets. Controller is fine, it is able to join the APs when they are on the same network. From the AP I am also ab...
Just received a replacement LAP from Cisco, connected it to my eve environment which has vWLC inside to check. found this new LAP cannot john to vWLC. system version on both side are 8.10.130.0From the prompt, can see the LAP get the ip addr and kno...
Just for fun ... me telnetting my AP at home minutes ago, and performing a 'sh ver':Who on earth can claim to own an AP that old ??? One of the rare cases where an IOS bug is funny [For Cisco developpers, platform: C9120AXI-E, IOS 17.13.1]
This might be a stupid question, but I have extremly little knowledge about multicast sadly.We're required to have multicast on our WLC because one of the VLANs are using bojour. For wired and wireless devices.I only want multicast active on this vla...
Resolved! Help out a Networking Student
Hello folks! This is a bit of an odd one so I appreciate your time clicking in. I am a college systems management student who is currently working on a research assignment with some particular limiting parameters. Mine are that I need to research exc...
Resolved! An access point that takes Fibre
I have two WiFi networks, one Cisco with 9130 and 9124AX APs and the 9124 accept SFP and the other net utilises Ruckus APs.I am looking at consolidating them and have one system, going Meraki and dropping all the controllers and other bits between wo...
Já tentei de tudo.Por cabo console, via web. Software putty, TFTP. Estou conectado com cabo console no AP e cabo de rede na fonte POE. Já mudei IP do meu computador mais não sei ao certo qual IP do CISCO. Alguém poderia me ajudar com um passo a passo...
Hi everyone,I have some questions about the best practices for configuring a hotel (or campus) Wi-Fi guest connection.Suppose there are 1500/2000 devices; is it correct to use, for example, a 10.1.x.x/21 network, or is it better to split the network ...
Resolved! WLC 9800 Webauth
Would someone kindly of explain to me what the use case is for the "type: authbypass" in the L3 Webauth configuration tab. This selection essentially looks like mac authentication bypass. If the whole point of having webauth is to solicit the user t...
I have an SSID set up with Radius and Microsoft NPS servers with wireless AP's as Radius clients. The two radius servers work successfully when individually testing with a phone. I use AD groups to set Meraki group policies. Works great. Now, I was t...
I have a couple of C9120AXE Access points which are unable to get DHCP assigned IP addresses on trunk ports with native VLAn set to the AP Management subnet but when port is set to access port with same VLAN it gets an IP. Anyone able to explain what...
HelloI can’t understand why everything is enabled in the SSID settings for 802.11ax, but in fact on the client side the network is not designated as supporting 802.11ax. Any ideas?Switch: Cisco IE-4010-4s24pPoE injector:Cisco AIR-PWRINJ6=AP:C9124AXD-...
Resolved! AP's showing as Wi-Fi 5 and not Wi-Fi 6
I did a survey using Ekahau for an area serviced by 9130 AP's on a 9800-40 WLC. For some reason the AP's are showing up as Wi-Fi 5 and not Wi-Fi 6 when looking at the 5GHz band. The 6GHz radios are disabled currently. Any ideas as to why this is ha...
Resolved! WLC 5508 migration
Hi, I have a site that will be migrating from a WLC 5508 to C9800-L, and my question is if the configuration on the 5508 can be migrated to the C9800. Thanks
