We have a problem with our cisco ap...AIR-AP1231G-E-K9 12.2(13)JA3 here is simple configuration:linux pppoe server---cisco ap---clientProblem is, when client tries to connect, there is no response from pppoe server. With any other access point everyt...
Hi,my customer have a Wireless LAN with one Root Access Point and a chain of 2 Repeater Access Points. All Access Point are AP 1200 Serie AP's with IOS 12.3(2)JA2.The customer use terminals with Interec ClientadapterAnd now the Problem.....The termin...
I have downgraded a AP1200 from 12.3(4)JA to 12.3(2)JA2 and my bootloader version is 12.2(8)JA. I need to install a bootloader Version 12.3(2)JA3. Where I can found it and how can install this bootloader files on my AP ??? thanks
Hi,I have installed a few WLAN sites. A number of customers keep complaining that the wireless connectivity drops at times (not most of the times). It drops and then it connects back in 5 seconds.I really don't know what are the reasons since the con...
We have just rolled out a new warehouse with AIR-AP1220-IOS-UPGRD running system software 12.3(2)JA2 and we are finding problems with the clients dropping off. in the past we have used 12.2(15)JA with no problems.Any suggestions?
Hello I would like to configure & INTEGRATE the following :1.Aironet 1100 for EAP with MAC authentication2.Linksys adaptor for LEAP authentication3.RADIUS for AAAPlz help.HTHSachin
I just received the new Dell Latitude D600 laptop and I had successfully configured WEP and other wireless related paramters so I have strong signal from my AP. However, I am not getting DHCP address. So I assign a static IP to my laptop. I can pi...
Is there anyway to get the Cisco CB21AG adapter running either under the ADU or the XP Zero config to interrupt the XP Ginas so it doesn’t try to contact anything on the network before the user logs in? In this particular setup the customer does NOT ...
Hello experts!!!Does anyone know the step-by-step procedures on how PEAP or EAP-TLS or Fast-EAP to do SINGLE SIGN-ON (SSO)? With LEAP, it has no problem. It is working properly. I've no problem if my clients are all using Cisco client cards but I hav...
Hi Folks,I have a terrestrial wireless system which uses the line of sight configuration. But the tower which transmits to me is far away (27 Km), due to this distance I am finding a troubles in doing the alignment and positioning the antenna.Is ther...
I have 4 ssids mapped to 4 vlans. SSID Guest mapped to vlan 100, FacStaff to vlan 200, Student to vlan 300 and CompLab to vlan 400 using AP 1200 and AP 1130 version 12.3(4). I have 2 radius groups Facstaff and Student using ietf radius attributes u...
