Wireless

Hi, Are there anybody here that have suceeded in upgrading a 1231G with the firmware from the controller version 4.1.185 (ap sw 12.4(3g)ja2) ????Best regards Henrik

I currenltly have a WLC running 4.1. I've setup DHCP on W2k3 many times with no problems at all. In the document I use from Cisco it states to use Option 60 to specify the AP Model. First is this option really needed, as I've got AP's working by just...

Greetings,I am seeing very strange behavior from my 2106 controller. When I load it up the firs time and run through the config wizard, everything works fine. When I then begin to configure my additional WLANS/Interfaces/Ports, it will at some point ...

We currently have a WLC 4402. We also have Cisco LAP1131AG Access Points. Our laptops are IBM Thinkpads with built-in wireless adaptors and with Windows XP SP2 on them. We have Microsoft IAS as our RADIUS Server. I've setup the environment, so that A...

I am seeing the following fault on my WLSE express: Radius server is not availableThe following is what I see in the AAA-server-trace.log:08/27/2007 20:15:23: P15467: Packet received from 192.168.50.408/27/2007 20:15:23: P15467: Checking Message-Auth...

I've just installed a AP 1231g as a local radius server and I've got two devices that are authenticated by the AP with the same username/password .is not there a problem?

We have an WLC 4402 with the latest code on it. We also have LAP1131AG as our AP's. We have an MS IAS as our RADIUS server. Is there a document on how to implement 802.1x for the internal Laptop users to use wireless networking in the office?Thanks.

Dear All,Can i use AIR-ANT3338 with AIR-BR1310G-A-K9-R?if yes what range it will give me in typical university campus?my purpose it to distribute internet on 2.4 GHz wireless for university students.AIR-ANT3338 is directional or ominidirectional ?tha...

Why is there 2 antenna connector on the AP ?

Hi. I wonder if you can point me at a table that defines the Reason Code(s) for Client Exclusion Failure? See the example event log entry below from a Guest Controller for Web Authentication failure (that was resolved - Internet router down) but I wa...

Hi,We have 3 Aironet 1310 Wireless Bridge. 1 of them is Root bridge, others non-root and Workgroup bridge. Normally ping delays are 6-7 ms avarage, but somedays 200-300 ms and timeouts. I dont understand what is the reason. Any other wireless telepho...

Hi All,For some reason all of the APs on a particular controller deregister from it and register with their secondary controller. Both controllers are running version 4.1.171.0 and I cannot see any issues on the LAN that would disrupt comms between t...

Hi. I'm having a problem with clients connecting to other clients or devices on the same subnet they are on.It might have something to do with ARP. As when i ping another device on the client, the ARP entry shows as '00-00-00-00-00-00 invalid' (is no...

I am having some issues with the initial setup of a 4402 WLC and 35 Cisco Aironet LWAPPs. The WLC and the LWAPPs are configured in the same VLAN and a DHCP server is setup to serve the VLAN. The WLC is configured for LAYER2. The LWAPPs show link ligh...