Wireless

I am in the process of testing PEAP in our environment using machine authentication with MSCHAPv2. I created a certificate on our internal CA and installed it on the ACS server. It works fine with XP workstations that are domain members. I would like...

I am extending a building automation system communication bus between 2 buildings approx 1200 ft apart in line-of-site roof-to-roof. Very low bandwidth is required. I'm considering the Aironet 1300. This is in Miami, so lightning may be a problem. Wh...

I am currently working on a wireless solution at a campus that has a main building (Bldg A) and two remote buildings (Bldg B & Bldg C). The two remote buildings each have a 1232 access point that provides wireless access to the Internet via Linksys A...

Hi,my topology is based upon 2 WLC 4402 in the same mobility group and RF group.The strange behaviour that i'm having is that, after I enabled the management via wifi, i can only access the WLC connected to the AP I'm associated.I tryied to move the ...

HiI am Kinda curious to study in detail the different station roles of the APs and the difference between them. Does anybody know where I can find this information? Thanks in advance

Hi All,Does anyone know how to recover the username/password whilst keeping the existing config and not defaulting the AP.

Good Afternoon All.I have several remote sites connected back to the main office via IPSEC VPN (netscreen) At some of these remote sites we have a Cisco 1130AG deployed for ethernet connectivity. A netscreen is put into DHCP-relay mode and points bac...

I have been trying to set up a radius server on a WLC controller. If the radius server's IP address is on the same subnet as the management (non-vlan) interface then radius works fine. I created a new VLAN interface in the controller on a 10.0.203.0 ...

Hi,Has anyone a idea what this Error Codes is?[ERROR] spam_lrad.c 13693: Received replay errorThanks for any help

I did,clear config,thenreset system(without saving).Then WLC rebooted and went into setup dialog as expected.What was not expected was that the,User:Password: were not back to default of admin, admin but had retained their easlier settings.Why were U...

On the Cisco Aironet 1500 Series Lightweight Outdoor Mesh Access Point spec sheet from the Cisco.com website, it states that the input power for the DC inline POE is 28.5 W at 48 VDC, nominal. What is the maximum power at 48 VDC? On AC, the nominal p...

I have a batch of 50 CF wireless cards (802.11b) out of which about 10 will not associate with our 877W router. They all associate with our 3COM "Office Connect ADSL Wireless 11g Firewall Router", a very simple device compared to the 877W. Both route...

I want to know how to assigne multipple ip address on a single wireless network card. I could do it in advance mode from TCP/IP properties, how ever it never remain stored after a restart of the machine unlike normal LAN cards. please help me thanks

Hi Mates,Please I need an affordable Cisco hardware or software (for SMB) to control about 200 clients in my wlan (hotsopt internet caffe) all work with two Aironet 1310 . I'm not concerned about security in the first palce, but Bandwidth, Filtering ...

dear sir, We've 2 AP at the same floor ( We named is AP1 & AP2. However we always get connected to AP1 , instead of AP2. How to control it? We hope AP1 can control 200M and AP2 control 200M. We are using Cisco 1202AP Please advise.