Wireless

I've just purchased a CB21AG 802.11a/b/g card and need help with the installation. I've downloaded the lastest driver install wizard v1.1 from cisco.com. I already have an 802.11b card and software installed on my machine - do i need to remove this s...

hello,i have the following problem:We have two 350 brigdes which we want to use for a point to point connection.But there is a problem with the connection.After entering the wep keys it works fine.But if i make any other change in config or reboot th...

As the new access points are shipping will they be supporting 802.3af? If not now, what month will they be shipping with this support?David BeaverInternetwork Engineering

I've forgotten the password to "Client Encryion Manager" utility v4.13 for the Cisco WLAN PCMCIA card.It is possible to recover from the above situation or a complete re-install is required.Thank you

Hello AllI know I can use the ACAU utliity to configure the card at installation, but is there any way I can put some profiles on the card after the install is done? The reason for this is I would like to easily push out updates for new APs through m...

Using a 350 AP running vxworks .Is there a method of turning off http and telnet access to the management port over the radio interface but still keeping access via iether of these methods over the wired interface (lan port).I dont want to upgrade to...

We have a few ap 350's. The firm ware was updated and now a few of the ap's are cutting out and restting them selves. The won't seem to stay up longer then an hour.Have treid restting them but no go. Not all of the Ap's are doing this, only about ...

I am having significant trouble keeping Dell PC's configured with the Dell True Mobile Wireless 1180 USB adpater associated with the AP. The AP has been upgraded to the most current IOS. I have contacted Dell as I believe that this is a problem wit...

It was my understanding the PEAP created an SSL tunnel for transmitting ALL of the user credentials. When I capture a PEAP authentication with my sniffer the user ID is passed in the clear. Is this normal or do I have something configured wrong?

I am using 802.11a/b/g cards and AP1200 v12.2(15)JA. I have have PEAP enabled.I seem to have issues roaming from one access point to the other. My signal can go to poor even when i am sitting just below a 2nd access point. Then eventually it will ass...

I have 1200 APs running 2 SSIDs. One SSID is using EAP and the 2nd SSID is using static WEP. Before i enaqbled WEP everything seemed to be running Okay. With WEP enabled i am kind of getting mixed results. One thing i have noticed i am getting a lot ...

I have 3 AP operating on CH 1 6 11When mine client it is connected to AP with CH 1, I have slow performance but I have verified the quality and Strength of the signal and I see a Excellent value.In the statistics page of the ACU and in the AP Radio P...

I am trying to authenticate users in a Steel-Belted-Radius (Funk Software) using LEAP and i am having problems when a specific users belongs to more than one windows domain group.I configured the three groups in SBR and set the PrequalifyChecklist to...

When connecting a Catalyst switch to an AP 1100/1200 ethernet port, what type of ethernet cable can I use - a straight-thru cable and/or a x-over cable? In the Cisco docs for describing how to connect locally to the AP ethernet port via a laptop, it ...