Wireless

HiAnyone know if it's possible to use repeaters in a 1000 series/WLC airespace installation?E.g. have some access points powered by mains, not attached to the wired network?I've seen references to mesh networks using 1500 series, where the BG radio g...

hi to allI am stuck in a problem, we have a aironet 1300 with yagi antenna we get the response but it was very hi i.e 1500 msecCan any body tell me wat can i do to decrease the response timeThanks

Background, we are using a Cisco 1200 series AP with a G radio card. We have the AP setup to do 128bit WEP. The clients are all 802.11b clients. The clients will see the AP, will associate, but will not authenticate. The WEP key are all the same. Whe...

Does Cisco have a doc that compares the features of their different wireless controllers?

what i have npw AP1232AG, WLSM and SUP720. i,ve implemented wlan for our internal users, via fast secure roaming. Now i want to setup the connection for external users. i have a seperate internet connection for external users . what is the best metho...

Hi,In my ciscoworks I have some vtp views but my access-point is in the view NO_VTP. I would like to place in the company vtp domain but this doesn't seem to work . I don't have any commands , there is no vlan database on the AP ?How can I configure ...

I have a network that has two 4404-100 controllers with approximately 65 AP's. I have a VLAN setup for WPA and ACS authentication, and the problem I am having is that I am dropping a ping or two when I roam from one AP to another. Is this something t...

Hi all,I've never worked with the 851 on the wireless side of things and I'm having a really hard time getting this thing to let me connect with my laptop and give me an IP address. I just want to setup something fairly simple with an SSID (non broad...

hi,i have a 3 AccessPoints on the same floor. i always got below disconnected message in the logfilewhat should i do. sometimes a client cannot connect to WLAN at all? please advise#######################################rface Dot11Radio0, Station 000...

I have root and non-root B1410 bridges. The root bridges will show temperatures in the GUI. The non-root do not. They show a WARNING: No Reading temperature monitoring is at 'INITIALIZE' state. What does this mean? I have not been able to find any re...

I have a couple of 1200 AP's with the G radio installed. We have several clients from various brands. Gateway/HP etc that have A/B cards on the client and are unable to connect to the 1200. It sees the SSID etc in the windows wireless configuartion s...

I actived Management Frame Protection in WLSE with 1131 and ios 12.3(8)JA.when any wds find error with Management Frame Protection, do anynithing that reset all (with blue screen) intel centrino with intel wireless card 2200 at the same time.The next...

How do i change the IP address of my AP 1200 access point through console mode ?i am able to plug in my console cable to see the bootup but i cannot go into config mode to make changes to my configuration.I need to change the IP address because i wan...

In my wireless domain, I'll have a WDS, with 40+ AP as infra client, and 50+ workgroup bridges as client to the infra AP .My question :1) Only need to enable workgroup bridge on the client, right??2) Do I need any root bridge ??Thanks.