Wireless

Hi all,I do a lot of wireless rollouts most recently using Aironet 1130 AP's. I've been getting reports of intermittent connectivity - but nothing consistent, i.e for a while it works fine in one area, then doesn't, then does again. I've done all the...

Hello - I have recently configured my 1231 AP (12.3.8JA) to perform authentication using EAP and WPA. I configured my Cisco ADU using a CB21AG card to do EAP-FAST and WPA with auto provisioning enabled. I also followed the Cisco config guide 100%. Th...

Hello --I'm having a problem where I can associate to an AP at my office no problem; however, when I take the AP to a customer's site it cannot associate to the AP, and at times my client has a hard time finding the SSID. If the SSID is found, my cli...

Sorry, if already asked...I try to config Wireless on Cisco 878...I want that switch ports be in one VLAN with Wireless port... and Wireless client be in one ip subnet with LAN clients...I use following instructionshttp://www.cisco.com/en/US/products...

I am looking at implementing building to building wireless using Cisco 1310 bridges. This would be a backup link between the 2 buildings. The primary link is 3 T-1's. There are about 250 users connecting back here for application and internet. I am a...

Hello,I configured my WLSE to check if my AP (AP1231 and AP1131) are SNMP reachable once every ten minutes. I want to have an fault only when SNMP reachability is down for 3 consecutive polling cycles = if an AP is down for 20minActually, I get a fau...

Does Cisco have a Path Calculation Tool for the 1200 /1300 series. I have the older tool, but it doesn't include 5.8 GHz or the newer products

As per setup B .The Wirless laptops are installed with AppGate client software.If I need to connect to the wirless network, there is AppGate Icon in the desktop of the Laptop.when I click a new window opens asking for 3 login details. Ie.. Open Conne...

Hello forum,We have just deployed WLC and WCS with couple of lightweight AP.We decide to employ MAC filtering to restrict wireless client.We noticed a SERIOUS problem, once we removed a mac address from the WCS and apply to controllers, Wireless clie...

We are deploying AP1020s and are having problems with users dropping connections on B. If I connect with a device that uses A, it will stay up no problem. The 1250s are an upgrade to our 350 series APs. If we go back to the 350 series, everything wor...

Is there a way to trunk multiple VLANs through a pair of1310 bridges without configuring VLANs on the 1310. I know I used to do this with the 350s but it doesn't appear to work on the 1310s.

Can anyone point me to good reading material for integrating a 4400 with Secure ACS for radius authenication / mac filtering?thanks!

I am using LXE MX3X terminals with Cisco 350 radios and Cisco 1200 Access Points. When I go into the Aironet Client Utility under the profiles tab, my active profile is <External Settings>. How do I select CAM mode when I am using <External Settings>...

Hi,i have an account with a Sip provider.I have all information for make a connection with xlite sip client but if i try to configure a Cisco Phone with SIP Firmware (7.5), phone not work.My provider is messagenet.it.Can you help me?Thanks