Wireless

Is ther any quick tip on how to configure 2 1200 AP's as bridges with high security.The AP's are supposed to be an extension to the existing LAN and not supposed to handle any wireless clients.Any response will be helpfull.

I just want to confirm something.From everything I've read on Cisco products there is not a Wireless bridge and anntena configuration that will allow me to set up a non-line of site bridge between two locations.Correct?I have a customer who has two l...

Hello allWe recently installed some new Cisco Catalyst 3560 that have some Cisco AP 1100 connected. Unfortunately, the WLSE logs all our c3560 as "unsupported device" in the discovery logs.This page claims they are supported:http://www.cisco.com/en/U...

hiany one know about wireless (aironet ,350...) simulator

Can someone tell me what channels to set inorder to avoid distortion when you have multiple floors. I know that channels 1, 6 and 11 are recommended for single floors but what do you apply for multiple floors ?

hi is there any Cisco AP's with 100 mbps or 108 mbp's Rf throughput.please reply.RegdsBinoy

I have a customer with a 1400 link that had the indoor power injector and power supply stolen.I am ordering the AIR-PWRINJ-BLR1=. Does this come with both the power injector and power supply?If it doesn't come with the power supply what can I order t...

I have tried the tftp/telnet method. I have tried force-reload, overwrite and leave-old. None of them work however.I tried the web interface, but It keeps saying software upgrade disrupted about 15 seconds in every time. I tried to use the tftp on th...

when I applied the upgrade through the web intreface and rebooted, the three lights are always on indicated a continuous boot, when I connect thru the console port I see only only very primitive commands such as c copy file, l load file, s system sta...

I swear that a few years ago we set up an Ipaq on CallManager and was able to use it as a wireless IP phone. We had CCM 3.1, and I don't remember needing any special phone emulation software. Is anybody familiar with this setup? We now have CCM 4.01a...

I have a Cisco 1200 access point running 12 2 15.XR2. I can't find where to disable broadcasting SSID.Again thanks in advance for you help!Will

We are running WLSE and 200 AP1131AGs.Many logs are save in WLSE everyday. Is there any option in WLSE deleting old log automaticaly not manualy? and If we don't have FTP server, is it impossible backup WLSE configuration and other logs?

Hi All,I want to use SNMPv3 as device credential in the WLSE. But, I don't know, how to configure SNMPv3 in the WLSE. Because I think SNMPv3 is using username/password rather than community string.Any help are appreciated.Thanks.Aris Cahyadi R.

We have several Aironet 1121 AP. When we try to connect a IPAQ (41XX or 5550) we cannot connect to the AP. Whe have tried settings such as Aironet extensions disable and Preamble short / long. Still the IPAQ cannot connect. Has somebody some suggesti...