Wireless

I am using a Cisco Aironet (AIR-CB21AG-A-K9) 802.11a/g/b Wireless Adapter. In the area that I am working the reception is not 100% and I thought that an additional external antenna might be a simple fix. Am I on track with the idea? Can anyone sugges...

We are using BBSM 5.3(SP2) at latest level of code.Problem:********Sometimes user sessions do not time out. (We are using the default page set "RadiusUBand")The packet inactivity timer is defined and should terminate ALL sessions automatically, but c...

Have anyone a clue how to use WPA with radius on Linksys WET54GS5 wireless brigge to Aironet AP1231G with Cisco ACS3.2 as radius? Can get WPA-PSK to work but authentication fails if i try the bridge to use WPA-Radius. Have tried to use both TLS and T...

Hi, My ACU is running version 6.0. I want to upgrade to higher than 6.3 to support EAP-Fast. Hoewever, the version available in the Cisco Download center is at version 5.x. I checked the bundle 2.1 as well. The ACU version is at 5.x. May I know where...

Hi,For some reason I can not access the 340 bridge through the console cable. I'm using a straight through cable and my hyperterminal settings are 9600,8,none,1,xon/xoff and I can not get the menu. If I connect to another 340, this still does not wor...

How do you enable or start using RTS/CTS. The layout of my network is long hallways with rooms on either side with AP's in hall and Nodes in the rooms off the hallway. I am sure I am running into the Hidden node problem but don't know how to enable m...

i upgraded with the cac tool and was able to get back to it thru the console and the http but the radio will not enablemessage in event log is Interface Dot11Radio0, failed - cmd busy any ideas? Mike Emenaker valley view hospital [email protected]

Has anyone successfully managed to get a WDS AP to authenticate with this box either using the box's internal AAA or an external ACS or AP local radius server?

I am struggling with an AP1200 install ... clients associating with the AP cannot obtain their IP addresses via DHCP.I have not been able to discover how to config AP to provide DHCP services. The AP is connected to a PIX firewall via ethernet, the P...

I have user who is getting these error messages from the Cisco VPN client version 4.6. Does anyone know what the possible problems might be.1 17:13:30.617 08/03/05 Sev=Warning/2 CVPND/0xE3400014The VPN Client could not find the adapters GUID - Virtua...

Hi,I've been working with Cisco 1310 bridges and 1231 APs. So far, I have used the browser to configure the bridges. I'm wondering is there a need to know the IOS commands to configure them. Does the IOS give more features to configure?. Or knowing I...

Dear friends,Our Access point is having a throughput of 54 Mbps.First of all I just want to know this bandwidth is shared or dedicated.Second thing some wireless users are having 54Mbps wireless card and some are having 11 Mbps card but practically o...

Is this device capable of Point-to-Multipoint connectiosn with the 802.11a radio? If so, how many bridges can it do?

HI everyone..Ok heres the scenario..I've setup an AP as a local radius server and I can get all my infrastructure APs to authenticate with it.. however I cannot get the WDS to authenticate with the WLSE.. see below outputs..WIG-ap03#sh wlccp wnm sWNM...