Wireless

In wlse is don't see he client or hostname when a devices is connected. Only see it's ip number and mac adress.Auth is done with wep and mac, in the dhcp server i see the full domain name. Anybody a idea why WLSE don't show the clientname?

Use FSR with EAP+MAC authentication with Radius auth. for the Spectralink phones.The Cisco ASC 3.2. server creates duplicate MAC address accountsfor some of the phones (2/3 of them, not for all).Username are completely the same (MAC addresses) for th...

Hello,I am having an issue getting EAP-TLS/PEAP (EAP-GTC) authentication to work. I am using a MS Server 2003, Standard Ed. server for my CA and a separate MS Server 2003, SE for my ACS server. I have completed all configuration steps outlined by Cis...

My company will soon start deploying 802.11b wireless into our 1700 branch locations. The stores are small and will only require 1 Ap for the most part. We have three concerns: 1)security 2)interference 3) managementDoes anybody here have a similar s...

I have users offsite connected to the main network via Aironet 1400s. In the past we have used port security statements on a 2950 to allow only specific Mac addresses on the link.I have had to setup a second vlan at this remote location and as a resu...

I would like to make our wireless network more secure but without using Certificates or PKI.I would like to get an ACS for authentication. Can this work with Netware 6 for username/passwords?What would be recommended for encryption? Can we just do WE...

When using the Cisco Site Survey Tool and NetStumbler, my CB21AG is not reporting noise levels.In the Cisco tool I have verified that "Display in Percent" is unchecked. Noise level sits at -98dBm forever - even when I'm near a noise source.When using...

The latest drivers V2.1 have been posted for the CB21AG card and I can download them without a cisco.com login ID - I supply email and other contact details. However, the rlease notes are only available to users with a service agreement. Is there any...

On the Cisco PoE for a Aironet 1200, the lights labled Power Status and Device Status are blinking opisit of eachother as soon as I plug in the cat5 cable to the device. What does this mean? Is the radio fried? Is there a pinched cable? Please help?B...

We have ap1100's and ap1200's deployed with dsl uplinks. When the uplink goes down, the ap still broadcasts it's ssid. Even worse, a host may associate with the ap, although it cannot get an ip address. It would be nice if we could run tcl shell and ...

anyone else having issues with these cards seeing the access points?AP IOS 12.3.4-jaRadio firmware 5.70.5Latest Dlink driversUsing XP's built in WPA supportWe have a radius server, 2003, use WPA-TKIP.I can't get these cards to see the access points a...

My company will soon start deploying 802.11b wireless into our 1700 branch locations. The stores are small and will only require 1 Ap for the most part. We have three concerns: 1)security 2)interference 3) managementDoes anybody here have a similar s...

Hi,To solve some roaming problems with ap1210's with Ios 12.2(15)XR2 in our distribution center, Cisco has advised us toupgrade to Ios 12.3(4)JA.We have done that but after 5 days, we got complaints with associations to the ap's.A reload solve the pr...

Our systems will be deployed in mountains where sufficient electricity power is not available, which requires small power consumption in the harsh environments. I have checked the specification for “CISCO AIRONET 1300 SERIES OUTDOOR ACCESS POINT/BRID...