Wireless

After having run a client walkabout the WLSE doesn't seem to register any location data even though the client walkabout job log reports WA measurements, i.e. measurements are taken but these are not translated into location data. Any ideas?The AAA s...

[1] Does the above standard Cisco Access Point has builtin DUAL RADIOS ? Plesae Confirm Thank you,Regards

If it possible to configure multicast video broadcasting over Cisco wireless? What kind of configurations should I made at my core WiFi switch (C3550) and APs?Any comments or links to docs are very appreciated!

I got when the WLSE start a configured Radio Scan this messages:%SCHED-3-THRASHING: Process thrashing on watched message event.-Process= "TTY Background", ipl= 6, pid= 17-Traceback= 12A194 12A3F4 6FAE4 13E20CI run 123-2.JA2. WLSE 2.11Is this a known ...

I just noticed all our 1200 AP's show memory useage in excess of 50%, even when no users connected. Is this normal given they only have 4.7M of memory?

Hi,I have a base station running the latest firmware (c1200-k9w7-tar.123-4.JA) and a repeater running an older version firmware (c1200-k9w7-tar.123-2.JA2). The Repeater sees the clients but does not pass through the DHCP addresses from the router con...

We own a big warehouse dim 180 (L)X 50 (H)X 120 (W) cubic ft.[1] we need to provide RF coverage inside and outside of warehouse. Therfore, please suggest me a Cisco "Dual Radio Access Point" and its Part Number.[2]Though we know that Cisco Access Poi...

I need a solution, where I can provide a wireless LAN with Internet access for guests. No client configuration can take place i.e Proxy settings.A splash page of terms and conditions needs to automatically pop up and if accepted Intenet Access can oc...

I'm hoping that someone can give me a quick answer to this (easy if you've done it) one.In the event that ALL devices configured as WDSes on a network fail, will the APs that are configured to talk to the WDSes, failover and authenticate clients dire...

HelloWith Cisco PC-Card is no problem to authenticate with leap. But I am struggeling with the meetinghouse aegis client installed on Symbol MC3000 with windwos CE 4.2.I tried with dyn. wep and ktip, but both failed with the aegis client. There is ab...

Is there a good source that states what channels are allowed/restricted in other countries? I'm having difficult finding such a resource. I'm currently curious about Mexico, but it would be nice to have this info for as many countries as possible.

Do Aironet 350 Series Access Points, or any Cisco Access Points for that matter, support RARP requests? That is, if a wireless client boradcasts a rarp request packet across the network to determine an IP Address from a given mac address, can the Cis...

what is a common cause of the virtual radio to go into a down state? Protocol always stays up. Only a hard reset seems to clear the problem for a few days.

We use WPA to secure our wireless LAN. Radius authentication and accounting are made through a external Radiusserver. The accounting record include only the NAS-IP but we need the client IP. We tried a configuration with Radius attribute 8 (Framed-IP...