Wireless

I'm helping a high school redesign their computer network and ran into a bit of a snag with the integration of a wireless network into the mix. Sometimes pictures are worth a thousand words:http://headnut.org/~squirrel/mhs/Network%20Topology.gifIn ea...

I'm working on rolling out a wireless network with 1200's and plan on having separate VLAN's for the wireless networks and management. Our current network has the management for our switches on VLAN 3. My question is, should I use the same VLAN (3) f...

Is it possible to force web requests from a BBSM through an upstream (authenticated) web proxy running (which performs web filtering). I'm getting the impression that this isn't directly possible unless WCCP is utilised. The BBSM uses ISA server as i...

Can the WLSM be used with the BBSM to aggregate public wireless access from a number of locations (using the mGRE functionality of the WLSM), with the traffic policy routed towards the BBSM?

I'm setting up some new Aironet WAPs. After I load the config I write memory. I can login after that and see everything I should but a day or two later, my tacacs login is gone and I get a password prompt. I have to console back in and reload. Any id...

Trying to reset the global password through a telnet session (over a slow link gui will not load). What are the commands to do this?? Thanks

Hi !Trying to get a Aironet 1310 (AIR-BR1310G-E-K9)working as it should, but see a stange problem after each re-loadThis is config before re-load :!interface Dot11Radio0 ! ssid XXXXXXXXX authentication open infrastructure-ssid ! speed basic-1.0 basic...

HI,could anyone out there pls help on what paticular product to use when deploying a wireles LAN FOR ABT 30 nodes that already has a wired LAN and the new wireless integrating with it ,,, The building is a three floor premises ,, with an installed LA...

My users are complaining that in an area where they used to receive a good wireless (802.11b) signal (100 ft from an AP), they now get a terrible wireless signal because many more people are using the AP. I did not think that more users would affect ...

Greetings members,I am about to deploy 2 APs with RM22A 5Ghz radio modules.I am going to use the 5Ghz Antenna AIR-ANT5145V-R. However, the cable that comes with it is only 90cm long, whereas I need a 3M cable, so I am going to get one made espesciall...

Hello, I´m having the following installation.A WLAN-Bridge connection with 2x AIR-BR1310G-E-K9-R with 13,5 dBi Yagi-Antennas. IOS 12.3(2)JADistance approx. 100 Meter.This connection runs for hours without any error.But at the Non-Root-Bridge from tim...

In an typical SWAN environment, are there any technical restrictions for not running both ACS and Ciscoworks 2k (LMS 2.2) on the same server? Any thoughts pro and con would be appreciated.

I have a question regarding using a Toshiba Tecra 9000 Series Laptop to authenticate to a Cisco 1200 Series AP. When I look at the compatability list, I see Toshiba Tecra listed as supported, but not the 9000 or 9100 series laptops. They are equipped...

Hey all,Anyone know of a way to delete all cleared faults?1 at a time just isn't cutting it!Thanks,-Brian

Hi,I have several Aironet 1100 access points and I would like to know if the following things are possible (if so, how to do them):- Force a client to be roamed to other AP (without disconnecting the original AP). I need to choose one or two clients ...