Wireless

We have Microsoft CA and we have installed the certificates on ACS but the certificate dosen't show up in the trust list. Anyone have any ideas? ACS will allow me to turn on PEAP but authentication fails.

I am new to Cisco gear and am trying to set up and test an Aironet 1200 running 'g' wireless backwards compatible with our 'b' users. If I turn on SSID broadcast my 'g' laptop sees it and connects automatically. If SSID broadcast is turned off the la...

Does any one know of a password recovery procedure for the WLSE 1130 running 2.7?

Hello,I am setting up a wireless solution and am in need of a bit of help. I have 2 1300s and a 1200. The building is shaped just like a backwards F. I have 1 1300 connected to the gateway then I have a 1200 acting as a repeater, and then the last 13...

Hello,I'm new to the Cisco forums so I just wanted to throw out a scenario and look forward to any responses. I have never used and wirelss Cisco products before (unless Linksys counts). I installed a cable modem to give broadband access to a new WIN...

I would like to deploy several Aironet 1230AG WAPs around 5 feet above the ground on an perimeter wall in a warehouse and then place the AIR-ANT3549 Antennas about 5 feet above the WAP. That way I can reach the WAPs easily, but still allow the antenn...

I have a AP 350 w\ IOS 12.2(13)JA2. The radio enables and disables itself every few minutes. None of my clients are able to associate to it.

I am trying to configure a 1200 series AP for encryption mode ciphers tkip and authentication key-management wpaI would like to define a 128-bit WEP key and I do not have GUI access to the AP. The doc says I cannot define WEP key for slot 1 if tkip i...

I have CallManager 4.0(4) installed with the version of Attendant Console that comes with it.Everything works fine except when we do a cunsultative transfer to an IP Phone, if the user does not pick up the phone and we end call, the display on the At...

All,I am looking for a list of Wireless NIC Cards that are supported by Cisco for communicating with a 1200 Series Cisco AP. I am looking to use LEAP as well, but cannot find documentation on what hardware models are supported for my situation. Any h...

Whether WLAN will work fine in multistoried Building for Internet Connectivity for all the flats in the building

Hi,I got some problems getting a wyse terminal with an 802.11B USB card connecting to our AP 1230.In the log I receive these messages: Mar 1 00:48:52.186 Information Interface Dot11Radio0, Deauthenticating Station 0020.e058.9c11 Reason: Previous auth...

I would like to reboot my access points once weekly on a recuring basis using the WLSE. I have tried using the custom commands in the config template, but it won't take the reload confirmation. Am I missing something here?

What should the throughput be for an AP configured to operate in g mode only? We are getting 12mbps using TKIP, and with no encryption we are see 22+mbps.

I m having no problems with using Location Manager on Win XP . But my customer's PCs run Win 2000. When I open Location Manager, it detects the JRE version, says its old, and lets me download the new JRE plugin. After installing the new JRE , Locatio...