Wireless

I have a client that asked me about a situation where they have a school with three floors and around 6 classrooms on each floor. It's a small school. A company wants to install 21 Cisco 1200 AP's in each room and in the hallways. The school wants...

I have a multiple 7920 phone and multiple AP in my environment. Some of the phones are hardware version 2 and others are version 1.When I do a site survey with 2 phones at the same exact spot I see diffrefnt signal strengths with each phone. both o...

Hi, Need some advise, some of my AP encounter the appended 0.0.0.0 ip addressing with state either is associated or association processing, Need valuable feedback, ThanksDevice Type Name IP Address MAC Address State Parent VLAN - - 0.0.0.0 0004....

Hi,I'm having some problems with phone roaming. The equipment is wireless phones 7920 with firmware 7920.3.3-01-05 and callmanager v3.3.3. The security is made with LEAP and it's working fine.The access points are configured in different channels. Th...

We have a Cisco 1100 Access Point 802.11g and configured to 128-bit WEP. We would like to upgrade to WPA-PSK. However, not all WLAN cards of clients are supporting WPA-PSK. Can someone advise me how to configure the AP to take both WEP & APA-PSK c...

Have set up 2 VLANs with SSIDs, as per the documentation on the Cisco site. Neither set to guest-mode. Problem is that unless the SSID is broadcast in the beacon the laptops cannot connect to it. Both of the VLANs have full L3 connectivity when it is...

Hello:When Cisco Wireless Security Suite will support IEEE 802.11i, WPA2, and AES?Thank you.

Hi eveyone,Have anybody tried to configure the console port of a 1200 so you can get to the AP via modem? (Dial-in)Thanks,ME

Hi - I have 1 access point for a small office. I wish to have 2 VLANs, one for guest users who bring their laptops into the office, and one internal vlan for company users who need access to the internal resources of the office. Reqs:1. Guest user...

I have installed 10 Aironet ap's throughout the bldg. All ap's are mounted from ceiling with antennae pointed down towards floor. I have been asked what the radiation pattern is for the antennae. I'm using 2 dipole antennae that is standard for th...

I am having a delay authenticating to my Aironet 1200 when first logging on using WPA to ACS3.3. My login scripts are not executing because of the delay. I installed the Microsoft patch KB826942, but still have the problem. No delay if I logoff th...

Hi bruce, we've implemented a wireless network in a school recently. there are about 30 access points covering the whole school but due to the construction we can see about 11 access points at any one time. my question is reagrding channel set up. we...

Have set up 2 VLANs on the AP but can only access the one that has it's SSID broadcast in the beacon. If the VLAN does not have it's SSID broadcast it is not seen by the laptop (tried 3 different one and a PDA). Can swap which SSID is broadcast and e...

I have an issue where a Cisco cardbus adapter causes a PC BSOD on whatever PC or different Cisco card is used. This only happens with Cisco a/b/g Cards and 1230 APs and only in a certain AP area of the building.Has anyone else ever experienced this?

Hi- Is it possible to Change MAC-Adress of a AIR-PCM352-Card ?my driver version is 7.29.0.0 (01.07.2001)- How can i update the firmmware of this 802.11b-Client-Cardis this possible with Tools ACU 6.3.011regards,Ralf