Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I need to connect 2 building, 100 meter apart, no obstructions. Need a mast antenna, directional. searched cisco web site and could not find one that fit. Does anyone have a recommendation ?thanks

poppj by Level 2
  • 514 Views
  • 1 replies
  • 0 Helpful votes

Hi, In order to make a wireless link of 17km can I use two 350 WorkGroup Bridges? Or should a Bridge be used? Over this link must pass VoIP. Thanks in advance,Leonardo

l.cabral by Level 3
  • 1108 Views
  • 4 replies
  • 0 Helpful votes

I have a large area, approximately 50,000 square feet. I want to use three 802.11b acces points, one on channel 1, one on channel 6 and one on channel 11. The coverage of all three access points overlaps each other in a very large area in the middle ...

Resolved! ordering AP

When i order a 1100 AP with this ref: (AIR-AP1121G-E-K9), do i need to order the AC power (AIR-PWR-A=) supparently ? or is it shipped automatically with the AP?

Hi, I am trying to figure out how a user will be notified that their LEAP/PEAP password is due to expire and how they can change it.I would like to age out passwords every 30 days and also force a user to change their administrator assigned password....

mdoyle by Visitor
  • 1064 Views
  • 1 replies
  • 0 Helpful votes

A business client wants to provide wireless Internet access to visitors, but wants to be sure that no visitors can access any resources on his LAN. Being new to Cisco, I want to know whether the Aironet 1100 or 1200 include everything we'll need to s...

matthyatt by Community Member
  • 914 Views
  • 3 replies
  • 0 Helpful votes

I have a Cisco Aironet 350 PCI card and internet connection via a cable from an antenna on my roof (wich is pointed to a public accesspoint in my neighbourhood). In the same computer I also have an ordinary 3Com ethernet card. Is it possible to conne...

nibj by Community Member
  • 611 Views
  • 1 replies
  • 0 Helpful votes

Here is the error message that I received during the upgrade. The previous upgrade went fine. I was upgrade from VxWorks 12.02.Memory Bank:File address size encoding type flags a) Config:AWC_ConfigDB FE020000 156 AiroDB1 Data 0000 b) FLASH :IOS_Upgra...

tlchant by Level 1
  • 768 Views
  • 2 replies
  • 0 Helpful votes

According to the documents I've read regarding dynamic VLAN assignment, a user can be assigned to any VLAN via RADIUS. Does the AP have to have to the VLAN manually configured on the AP's Fast Ethernet?Is there any form of VTP available to advertise ...

My AP1220B with a 15dbi omni is at 160' over flat farmland. I can "see" at least three other similar strength competitors on channels 1, 6 & 11 with NetStumbler.The best frequency for me appears to be channel 1 because SNR is the least from the other...

mwachtmann by Community Member
  • 663 Views
  • 1 replies
  • 0 Helpful votes

hellosuppose we have a wireless client using an encryption key with an AP.when a client roams from that AP to an other, how the new AP will learn about the key used by the client.must we configure the same key in both AP? or must we use a local route...

Topography: Two bridge units using 6DB patch antennas across a concrete parking lot, at 100mw input. Near side is attached to 10/100 switch and the rest of the network. Far side is attached to 10mb hub with 6 clients. Radios are reporting high levels...

bkempter by Community Member
  • 791 Views
  • 2 replies
  • 0 Helpful votes

Hello.We have a test with an ACS 3.2, 1100 AP and run PEAP for authentication. I have read that it is possible to deliver dynamic WEP-keys from the aaa-server to the client but not sure how and how to verify..Setup:ACS with PEAP enabled (works fine)C...

walruspro by Community Member
  • 1251 Views
  • 4 replies
  • 0 Helpful votes