Wireless

Our company has a centralized IS department. We go out to the remote sites, do a site survey and install a wirless network. But over time the layout of the building may change and that in turn will cause a change in RF reception. I am looking for a s...

Hello,I try to use PEAP in our Wireless Enviorment.Authentication works fine, but only when I'm always be logged in on the Machine (Logged in Localy).What I want is PEAP Authentication run before theNetwork Login so that all our LoginScript's runs.En...

I have downloaded the driver and installed. When i try to open ACU , i get " No Radio " found. Any help would be appreciated. Thanks

I would like to know where to find a comparison specifications for the AP 340 Vs the AP 350. I am aware of the difference in output power 30 mW Vs 100 mW and I believe the 340 is limited to a 40 bit encryption code. I know the 350 is supported by pha...

dear friendswhich 1200 series 802.11b AP should i go for AIR-AP1220B-A-K9 or AIR-AP1230B-A-K9well i guess it looks same but, notice the 30 in the second option.thanks in advance

Do you know whether AP1200 with 802.11g can support 802.11b and 802.11g client at the same time? Is it auto search for bandwidth requirement?Thanks!

Please help to know the differences between AIR-BR350-E-K9 and AIR-WGB352R ? what is ETSI Cnfg ? Thank you very much.Dvu

Hello everyone, we would like to setup a wireless for a building with 5 floors to have to have wireless. The buildings are about 100ft height and 60 wise. We would like a laptop to be able to access the network even when we are outside the building. ...

Is there an option to turn of remote administration of the Cisco 1100 AP. I wish to allow only machines on the cabled network to administer the AP's, not wireless clients for security reasons.

Hi, I connect my wireless LAN to wired LAN using Cisco Aironet 350 bridge. The wired LAN connects to the Internet using Cisco Router 1700. I have 20 PCs on the wired and 15 on wireless with about 5 APs (Cisco 350). I also have a small bandwidth of 12...

We are using a IBM T40 (with 802.11b build-in). We are able to surf web and ping successfully. Once we transfer large file, the connection just drop and the debug log from the AP1200 shows:Dec 18 10:39:57.095 H: %DOT11-4-MAXRETRIES: Packet to client ...

HelloI have a little question about different VLAN's on a AP 1230 and the Trunk between the AP and a switch.The Situation is, tha we have the VLAN's 1 ( native ), 22, 153 ( voice ) and 192. All VLAN's exists in the wired LAN. The AP is in the IP Rang...

Does anybody know if the universal power adapter is plenum rated for a 350 bridge? I know the bridge is plenum rated but the docs show nothing for the power supply.Seth

PEAP + Dell WNics + ACS + NDS/eDir + Novell Cert Server -- Can it work?I am supposed to do a global WLAN rollout next year and would like to use PEAP, but we are a Novell shop and use the Novell Client. Should I attempt to go down this road, or take ...