Wireless

Can anyone point me to a reference on what these MAC addresses might be?03:00:00:00:00:0101:40:96:ff:ff:ff01:40:96:00:00:0001:00:0c:00:00:00We had thought they might be multicast but have not yet found any info to back that up. We are seeing these mi...

What kind of amplifier is recommended for AP 1200?Please helpthanks,Khurshid Khan

Does any one have any correlation between signal strength in dBm with that of the percent. Can it be as simple as comparing in a chart or is there a calculation that can be used. Or is this a matter of the "magic" of RF.

Gentlemen:I am working on a Cisco wireless project. The 1200AP got its IP from a DHCP server. But when I displayed the network interface, I found it has one 100M ethernet card and 11M AP radio interface. I thought that 1200 AP has a built-in 802.11a ...

Is there a formula for converting from percent of signal strength to dbm? A lot of my customers relate more to the percentage value but most of the programs I use are easier to use with the dbm value.

We've started placing 1100s in our network. We've used 350s for some time and have noticed that the 1100s don't appear to have near the strength of the older 350s.The clients report higher strength from further distances connected to the 350 then the...

Has anyone ever found out why on a BR350 the ethernet light will start flashing red and the unit stops passing traffic? I was hoping 12.03 would fix it, but nope. Signal strength is over 60% and usually the unit works fine at 11mb. It's not a bad uni...

We are using the IOS version of the Aironet 1200 series with the 802.11B radio. In the event log, we have been receiving the following message: "Packet to client [mac] reached max retries, remove the client". When examining associated clients to the ...

I am currently using 352's at some of my plants, but am looking to increase coverage. I am worried about the 300 series becoming EOL. Is there any information out there with a comparison of all the different series AP's? Any compatibilities issues?Th...

I am able to get PEAP-GTC/on Win XP working without validation. With validation I get a error message ."PEAP validation failed, status=-16 error code=-2146885628.Please make sure that PEAP is installed correctly and Trusted root certificate is instal...

Dear MembersCan i connect two PCI WLAN 350 adapter cards in adhoc mode to connect just two PCs. is there some problem in this ?what is rf output power of aironet 350 client adapter cards ?regards

I have set up VLANs on my Aironet 1200s in my test lab, and have got them to work successfully. I have also been able to use a VPN connection to gain network access on the open VLAN. My question is while using the VPN client,(1) will roaming be affec...

Has anyone sucessfully implemented Dynamic VLAN assigment. I have not been sucessful. I am using at IOS Based 1200 with ACS 3.2. I am using PEAP as the authentication mechanism and I have tried both SSID assignment and VLAN assignment VIA RADIUS and ...

Hi All,I am in the process of updating my AP1200 from ver. 12.01T1. I will be using LEAP and vlans. Would you recommend I stick with VXWorks or should I move to the latests version of IOS? Thanks,

We have currently purchased a test laptop with the new intel 2100 card that "supports LEAP" Intel Is telling me that drivers must be obtained from Cisco. I have tried teh ACU which obviously does not work being it is not an aironet card. Anyone try t...