Wireless

Hi Which packets are sent as multicast and unicast packets in WLANs ?Thanks and regardsVijayendran

I need to install 2 antennas for independents point-to-point links, in the same mast.Which is the minimum separation recommended between the antennas?

Hi,Can anyone tell me if WPA will be supported on 340/350 APs? If so, what is the time frame?Will the firmware on these AP be upgraded to IOS? Please advice. Thanks in advance.

This maybe a bit off topic but I am struggling trying to get some answers out of HP.We have some HP iPAQ 5450/5550's all running Windows Mobile 2003 - to use 802.1x Authentication with PEAP or TLS-EAP we need certificates installing on the PocketPCs....

I have a Cisco AP 1200 running IOS version 12.2(11)JA. I am applying an access list to the F0 interface to restrict outbound traffic. When I define an extended access list, it works OK. If I add the log option to the access list, no traffic passes an...

After the last firmware upgrade to 12.03T all the access points that I had forced to the left or right side (depending on the antenna AIR-ANT1728 placement) seem to work better if I set it back to diversity.Any ideas on this when 12.02T did not give ...

Does Cisco plan on releasing a USB wireless adapter? If not, does anyone have any knowledge of a good USB vendor which supports non broadcasting of the SSID & 128 bit WEP that will work with the Cisco 1200 AP's? We must use USB adapter's here and bot...

Reoccuring problem with latency (avg. delay) on a set of BR350 wireless bridges.Here's a breakdwn of the setup:BR350 with a 12dbi Omni antenna on one end of the linkBR350 with a 19dbi grid dish on the other endEvery morning I run a link test on that ...

Hi, our custormer recently faced a problem about AP350. Their ap350 always accidentally stop passing traffic. The part of logs were shown as following:2003/08/27 18:14:04 (Info): Station 00070eb8cb1f roamed2003/08/27 18:14:04 (Info): Station 00070eb9...

Hello,Does anyone know where I can find some guidelines for a site survey.regdsJohnny

Hello,I need to repeat a signal between a big wall.AP1-< ~ >-AP2-< ~ >-WGB1AP1 is rootAP2 is repeaterI know that using a splitter is not recommended in AP2. So on AP2 can I use an directionnal antenna directly attached to Right connector and a second...

I've just bought a 2nd user AP-350 but can't reset it. I have found its IP address using CDP from a connected switch. When i browse or telnet to it i'm prompted for a username & password. This is the same for any console access.I have followed instru...

We have a 1200AP with both 802.11b and 802.11a antennas. Now, the documentation for the 802.11a antenna (flip-top antenna on AP) says it may be a omni-directional or patch antenna functions.Does it perform both? If not, how do I switch from omni to p...

Got two new AP 1200s. came with the VxWorks OS in it.Wanted to upgrade the image to IOS 12.2 JA.Downloaded the VXWORKS-to-IOS conversion image, and started upgrading the AP, via the web browser. In between the upgrade, due to a power outage, both APs...

I have an AP350 shooting a link to a WGB350. The link is about 150m wide. On the WGB side there is a hub with one IBM Netstation connected. They have been stating that everytime they need to use the netstation they have to reboot it, to get it to con...