Wireless

Hello,I am trying to configure a Radius authentication for an administrator logging on an AP1200 via HTTP. On the Cisco Secure ACS server I can see that the authentication was successful and with a trace I can see also the 'Radius Pass' answer coming...

How does the AP and end device know what speed to synchronize to? If the end device is transmitting at 60mW and the AP is 100mW who decides the conversation speed

We presently have many 1200 AP's installed throughout the factory. We have them mounted on columns approximately 12-14 feet off the ground and we are not having any problems with this. I have read that they should be mounted higher(maybe 25ft). That ...

I know in theory this stuff all works together, but let me ask the question.My customer has Compaq EVO Laptops with the Compaq W200 wLAN module attached. They have bought ACS3.1 and AP1200s, and want to run PEAP authenticating with their Windows AD e...

What is the latest WLSE software revision. Does anybody know where the software and release notes are located. I cannot find them anywhere. I am trying to upgrade AP340 firmware to 12.02T1 via the wlse and the job continually fails. I am assuming thi...

I have these warnings in the AP350 log... do you know what could be the problem ?, thank´s.(info) : Deauthenticating [LCL-3-INSP]000b46bd4392, reason "Inactivity"(Warning): Failed to address or send packet to [LCT3]000b46bd3e70 (status=-1)(Warning): ...

We have in our factory AGV's(Automated Guided Vehicles) that roam about the factory. I would like to connect those to our wireless network using 350 workgroup briges. I need to mount the WGB under a hood of the AGV and mount the antenna outside. Is t...

HI i have installed Ap1200 with the latest firmware 12.2.t1 with 2 vlans and have leap on both vlans. i have also broadcastkey rotation on. i have the phenomenon that i get "sometimes" a DHCP address and sometimes not. does anybody has the same probl...

Im trying to connect to sites using a wireless 340 bridge with an estimate distance of 17KM. During the association process, im not sure how long would it take the devices to associate. There should be considerable latency for this but would it take ...

Microsoft recently planted this driver on my laptop and now my AIR-PCM35x has lost it's plug & play capability. Recovered P&P after rolling back to 8.2.3.Interesting to note that CCO doesn't host any release notes for the latest drivers.Comments & ad...

Hi,I am trying to connect the Toshiba laptop with built in WI-FI solution with AP1200. I have configure the WLAN card but it doed not connect with AP1200.This is the first time, these laptops comes in with WI-FI...Can you please advice me which is th...

Hi,Does anyone know if there is, or if there will be a solution for upgrading my "old" AP1200 to the new IOS software?Regards,Bjorn Fredriksson

I'm already CCNA and CCDA and i've already done many other Cisco courses, i guess to achieve CCDP certification this year.I have spent the last two weeks deploying a small wireless campus with Aironet 350 AP and aclient adapter. I'm now starting with...