Wireless

I have problem with LEAP authentication between my Cisco wireless group devices and Win 2k Adv Server. On my Win 2k Adv Server in EAP methods there is only one authentication methods MD5-Challenge. Maybe someone knows how to install another authentic...

Hi,How do i connect the following : Bldg A ------> Bldg C (serving as a repeater) --------> Bldg D Bldg B ------->Do i need to deploy all the wireless access point as workgroup bridge (for bldg A, B, C and D) ?Cheers,Toh CS

I have a 342 AP that when powered up, you can see it and try to associate for about 3 secs. after boot process, then it disappears and the only thing that can see it is the other 342 that is in range of it. No clients can see the device using either ...

I'm running IAS on Win2K server (added patch for PEAP suppport, box is a domain controller in an Active Directory); XP client with SP1; Cisco 352 (tried firmware 12.01T, 11.23 so far); tried both a Cisco 352 card and a Linksys card.In the event viewe...

Is ther any way to authorize client using it's logon information, using the same domain server than the one used for login pourposesThanks in advance

Hello,I have two bridges that will connect between two sites that are less than one mile apart. My question is what can I use to test signal strength and help me fine tune antenna alignment. I only have the two bridge units for this test. Any help wo...

I need to block some ports on an Access Point that I have model 350. I went to EXPRESS SETUP\Associations\IP Port Filters Tab. Is this the place that I can block specific outbound port numbers for folks trying to surf stuff that they are not supposed...

Hi,my company want to move to a new office building. As of today we run our own Cisco WLAN and of course want to move this with us. However, the new site already has WLAN implemented by another company. So my question is: is it possible for us to run...

I have an Aironet 350 running 11.21 that keeps broadcasting the SSID about 500 times a minute. Is this a software bug? I was unable to find anything like this in the Bug Tool.

Hi,Is it possible to change from an American radio system to European one that allows to use radio channels 12 and 13?Tere is any documentation regarding that? Where can i find?ThanksNuno Santos

Please any one can advise me why the bridge said that it works at 11Mbps but when we do a testing with 2 Aironet bridge AIR-BR350-E-K9 the maximum throughput I can get in the idea situation is 6.6 Mbps only. So what is the real throughput of Aironet ...

I connected TRENDNet TEW-210APB as AP Clent to AP350 with 12.00 software but they dont work properly.My frends say me that TRENDNet TEW-210APB as AP Clent to AP340 with8.55 software work properly

We have a community that wants to have workstations auto login using the Tweakui utility from Microsoft. (I know this is a bad idea in practice and we've fought the good fight but they wanted to have it and there ya go) Anyway, since moving to LEAP a...

I use aironet br342 with 2.4dBi dipole as access-point.I found that when I use ping -t with a pc , over 10 packets time out from time to time , while the signal noise rate is still quite good .Further more , I found that when I open about clients the...

I have an AP 350 as the Root/AP, and an AP1200 as a repeater. The 1200 keeps reassociating to the 350 every 10 seconds to 10 minutes. I have a 40% signal, which should be good enough to keep connected. Sometimes the 350 will say the 1200 "roamed" and...