Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
My Dell laptop has a Microsoft laptop wireless card (MN-520) which connects fine with my wireless network at home.At work we use Cisco Aironet 350 Access Points and I am trying to access that network using the same card. But I have had no luck so far...
On many of my clients I am getting "IP Address: Unassigned". On others in the same area it works fine. Of these all of the clients are Laptops with Agere client adapters inside, or are the Orinoco Gold cards. I think they stopped working when I upgra...
Hello, evryone,Are the following two WLAN network desigs (topologies) correct or no?1. BR350 root -----BR350 non root======BR350 AP mode---------WLAN Clients (Desktops) or WGBs3502. BR350 non root------BR350 root======BR350 AP mode---------WLAN Clien...
i have a this network design:Router === BR-Root ----- BR-Cleint === BR-AP ----- WGBWhat is the collision domains for this network design ?
How can I make my repeater stay authenticated? When this happens I cannot get to it to program it or debug the network.Thanks!-Jay
I am tryiing to install a cisco aironet wireless LAN using Windows 95 but I can not get pass installing the hardware. Please help.
Hi guys,I have a Aironet AP1100; the users should be authenticated throught the radius server in the EAP-TLS mode or in the open authentication mode.this is my configuration for the authentication in the ssid:! ssid AIR-TEST authentication open authe...
How can i configer my AP 1200 to broadcast SSID on 5 diffrent VLAN's?I succeed to broadcast it only on native VLAN.
This may sound rather naive...however, in my pursuit to understand the PHY layer, if a Radio is transmitting at a frequency of 2.4GHz, then this means 2.4 billion sine waves per second. Hmmm...then how come you cannot place a bit on each sine wave an...
Hi all!Is there any way to configure the 1200 Ap not to change to Repeater mode when the Ethernet Connectivity lost.?
Is there a limit of the filtering entry for the Aironet 350 access point?I check almost all the 350 related docs, and can't find anything.regards,Karl
What extra loss is added if you interconnect a CAB020LL-R and a CAB050LL-R? Since these cables come with Male/Female TNC connectors. Can you not connect them tohgether to get a 70' foot cable?Bob
Whats the last supported BR500 firmware and how can I get it?Thanks in advance -Danny
I would like to set up some access points where customers can access the internet. The idea is to give wireless access to outside customers (each of them should have username and password) which has nothing to do with our corporate network. I have an...
I'm using many AP and BR in 2.4GHz for outdoor connections. I saw that the new product Aironet 1200 can be used with 5,7GHz frequency but it does not have a RF connector for an external antenna.Will it be available some day with RF connector ? (like ...
