Wireless

hello engineers ,recenty i've been offered to make a wireless-base network .i'm wondering if i could do my job by using cisco wireless equipments;min link bandwidth is 2mbps and max distance goes upto 35 km ,point to point .your comments are mostly a...

I have two 350s, point to point with Yagis. ~1000 feet. Signal quality is 97-100%Every 15 minutes or so the link dies and it re-associates. (error states-lost authentication with Parent ) When I disable WEP everything works fine. Are there any known ...

Hi,there's one PCI card for 802.11b, but none for 802.11a.Anybody knows if CISCO is in the process of introducing the one?Or it waits till 802.11g is going to be approved in June-July 2003...?---Any PCI cards for 802.11a that CISCO recommends??Thank ...

I have 2 sites separated by a 5km sea. I want to connect a LAN on a ferry to only 1 site at a time (limited by ETSI-regulated power and hence range). Can I use an all-bridge design and have the 350 bridge on the ferry roam between the two sites? How ...

We are investigating a wireless solution for a mobile DR unit & I am wanting to know if a generator would interfere with wireless comunication. The generator would be in close proximity to the network and I was wondering if it might casue some proble...

Hi allWe have about 100 locations (1000 AP´s) connected over a FrameRelay WAN. Now we want implement LEAP. Question: We have 2 redundant ACS for Authentication in the headquarter. Is it a possible solution to take these ACS ??

What's the history behind the 802.11b channels allowed in Japan? I have read where the IEEE Std 802.11b-1999 standard said only channel 14 was allowed. I have also seen several documents; Cisco’s included, that all 14 channels are allowed. I understa...

I have a problem with 340AP while I use appletalk protocol. but it works fine when I use my Mac Laptops with TCP/IP connection. do I need to make any changes in the the AP configuration so that it allow the Appletalk protocol...if any one has an answ...

From the "Cisco Aironet Wireless LAN Client Adapters Configuration Guide for Windows", it indicates that Windows 2000 can support host-based EAP with the "Service Pack 3 or greater and the Windows 2000 Wireless 802.1X hot fix". However, I cannot find...

as I connect three AP 1200, in which mode must be each one of them,ssid can be the same one or I must change it?

It seems there is a problem between the ethernet port of a 350 series wireless bridge and the ethernet port of a 4005 3com switch. Symptoms:when you just connect them one to another, they work just fine, but after a while, maybe 4 hours, maybe 1 or 2...

Is there a way to configure the Client or ACS server to allow for the changing of an expired password?It appears that if a LEAP enabled client attempts to autheticate to an Access Point via ACS that is configured to point to an NT active directory fo...

Various literature indicates that the 5Ghz Antenna is a 6dbi patch and 2dbi dipole. Can anyone please describe in detail the features / funtions of the antenna. (What physical position does the antenna need to be for what function?)