Wireless

Will it be any interference to the wireless radio signal by a satellite TV dish (vsat) ?Thanks.

I have 3 repeaters connected to 1 AP ( as root). All unit are using same SSID, different radio channels. Other settings are default.However, all repeaters are intermittently associated & disassociated with the parent AP, at least every 2 minute. What...

I used this link to help me configure the ACS and the Cisco 350 Access Point.http://www.cisco.com/warp/public/cc/pd/witc/ao1200ap/prodlit/wrsec_an.htmAll I want to do is to only allow certain MAC address to associate with the Access Point. No LEAP or...

Hi all,i have a big problem.well, i have 3 cisco aironet 350 series and i lost password.how to recovery my password ??? the version of used software in these bridges is Aironet BR500E V8.24please, help me !!!!!tks...

Can anyone tell me if WLAN is usefull at remote locations ? I could not understand the limitations interms of distances... miles/meters etc.. Thanks,

I noticed that there are two differnt types of workgroup bridges. They are:AIR-WGB352C: One nonremovable 2.2-dBi dipole antenna included AIR-WGB352R: Two RP-TNC connectors (antennas optional, none supplied with unit) What type of application would de...

Cannot even connect via hyperterminal with required settings. Plugging in with ethernet doesn't do anything either except I get a blinking light on the switch. Never any light on the device.

I have been running couple of 350 bridges for about a year now. My firmware is at 11.23T. I am looking for information, hopefully a step by step, to enable the highest level of encryption / security that I can.I am running these in bridge mode betwee...

We started a video conference from a wireless workstation - a Cisco 350 client associated with a Cisco 350 Access Point.We successfully transmitted video and audio from the wireless to the other station on a different ip network, but we were unable t...

Is it possible to connect a AIR-LMC352 to an AIR-ANT3549 and if so what part or manuf. cable would you use to conenct the MMCX on the card to the RP-TNC connector on the antenna?My hope is to use this to communicate back to a 350 Series bridge in AP ...

Hi everyoneWe are looking at the possible creation of a "video only" network for the transport of our clients H.323 videoconferencing traffic throughout our community. Does anyone have any experience transporting H.323 video over wireless networks? A...

I have one Br350 set up as a 'Root Bridge' connected to LAN A core network and the other as a 'Non-Root Bridge w/Clients' connected to LAN B remote LAN, only SSID is configured .The non-root bridge at LAN B connected to DECRepeater 90TS(confirm good ...

my cisco 350 AP cannot associate with Symbol wireless cards. I already tried checking the Non Aironet part in the config for AP.

If i am having a 1200 ap from aironet ,can i use this ap with a client adapter which is of different make?(talkin about .11a standard)

I have installed last week eight AP-350 with some PC to equiped Cisco PCMCIA Card wireless.All it worked in order.Today customer called me to say that some PC can't connect through AP to network.What it can be ?What can I do to troubleshotting ?Thank...