Hi team, i have wlc 9800 i have connect only window laptop and android phone issue mac laptop and apple phone not connect ssid and not getting any log i am not use any local profile how to resolved this problem
Forum Posts
Hello, I am studing Cisco's technology, and I want to make a LAB environment in my home, so I used 3 older 1700 series autonomous AP, and I tried to change the authentication method to username and password by using local RADIUS built-in. But no matt...
Hello, occasionally I have to switch an access point (AIR-CAP702W-E-K9) to be an autonomous bridge. Right now we use 2 WLCs for this. The main one is running all the APs and the other one is for testing and for the process to get the bridges autono...
Hello.I have one AP AIR-CAP3602I-E-K9 with installed Autonomous AP IOS Software- 15.3.3-JF15(ED). I recently purchased a module 802.11 AC. During the configuration I found out that it is not possible to turn on AC radio in autonomous mode.https://qu...
I recently bought this Aironet, which I hope to use to connect an old MacPro to a wireless network.I have been through the motions of resetting it (hold down Mode, plug in to power, wait until Status shows amber, then wait). I understand that this, a...
Hi, We are running version 8.2.100.0 on two WLC 5508 in HA mode. When I enable my syslog server, a lot of theses message arrive periodicaly. Do somebody saw this on their controller ? It's only on 2.4 band. Not on all AP. *RRM-CLNT-2_4: May 30 10:...
Resolved! wireless network in a building
Good day,I need to know the materials needed to create a wireless network in a building, you will find some information:- The building is 30 meters in length, 10 meters in width and it is 2 stories high.- The connection to be shared is a 100MB Fiber ...
Resolved! 9800WLC-in HA red alarm active node
Hi team, i have 9800wlc and configure in SSO mode HA configure but in active node red light showing how to resolve this issue
how to change IP adress of wireless controller 2504 . from GUI
Resolved! Cannot connect to LDAPs using WLC
We have a WLC, that we'd like to authenticate users against LDAP. However the WLC fails to establish a connection with the following error: Failed to start LDAP over TLSThe LDAP server itself is set up correctly. I have tried accessing it using an LD...
Cisco 9800 with third-party authentication serversI am trying to integrate through web policy. I read the manual, but there are many things I don't understand. 1. Is aaa server really necessary? 2. In Authentication of AAA Method ListWhich type is co...
Hello,I have convert C9120 ap from Embededd WLC to CAPWAPP.Unfortunatelly, I don't know if there was a factory reset or something else, but my AP are joining one local AP Embedded controller that I had already convert !I have to convert once more the...
Resolved! Need help MAC Filtering - Clients list
I have been trying to setup our wireless network. I have setup several SSIDs but I need one to access the network and filter by mac addresses. I was trying to use the instructions here: Using a Sign-on Splash Page to Restrict Wireless Access by MAC a...
Hi, For some reason, one of our APs just rebooted on its own. Here are the controller logs when the AP went down. According to Cisco this is nothing but I doubt as it caused the AP to go down after these messages. *RRM-CLNT-5_0: Mar 04 10:40:16.867: ...
Resolved! vWLC license
Hi, Please see below highlighted with triangle. The first one has "60 day evaluation license" and second one does not have. Why it has difference between the two? The first one need to buy license after 60 days? and the second one cannot work at all ...
