Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
We found a couple of old 1141N AP's in our network that were not associated with the controller. Upon investigation I found that the MIC had expired. We are currently running 8.3.133 on the controllers. If this command is used in the shot term, (unti...
Let's assume thatAP1 is on channel 40 width 80mhz, AP2 is on channel 48 width 80mhz, It overlaps.As far as i understand 802.11ac has a functionality which detects width utilization per-frame and falls back to a much lower channel width. If AP1 detect...
Going back to basics here what is the recomendation for uplinks / trunk connections to Cisco WLC in terms of spanning-treeOur WLCs are setup to use LAG and we're trunking multiple VLANs across the trunk to the WLC so i would imagine spanning-tree sho...
I am planning to install 9800 with HA configuration. It's Active-Standby. When configured as a port-channel, what will be the status of the port-channel of BB connected to standby 9800? suspended?? stand-alone??
Hi guys,I need to know maximum theoretical/technical supported clients for the Meraki MR53 and MR53E.Are there official Meraki documents where I can find this information?Thanks,Samuele
Hello,We are currently looking at setting up a radius server to connect our users/devices to the wireless network.So far we have that part working for those devices that support wpa2 enterprise.We have a few devices (TV etc) that do not support this ...
Greetings, we are currently trying to integrate a provider's entertainment system with our network. it is called zafiro cast and uses a chromecasts installed on the TVs inside the hotel rooms. they gave us this document which i attached here as their...
Is a 3D Solidworks model available for the new IW9167 access point?We were able to get one for the older IW3700, but the details on this one are a bit different.Thank you!
Hey Gang,I am running 8.10.171.0 code on my 8540 WLC HA Pair. When running a debug client xx.xx.xx.xx.xx.xx yesterday I receive a lot of the data that I will paste below. Has anyone else experienced this? Maybe a bug when running debug?There were hun...
I am trying to get dynamic VLAN working using the locally switched VLAN name between a 9800 WLC and ISE over flexconnect. I can only get this to work if I have the name mapped in the flex group but this statically maps the VLAN name to the ID. Has an...
The port on the switch it is connected to will show connected and then not connected a few minutes later. This continually repeats. I also cannot see the AP on my WLC. This is not a new AP and has worked before.
Hi All,I'm working on another migration from a Cisco 5508 WLC with a 5508 Guest Anchor to a Cisco 9800 WLC and 9800 Guest Anchor. I'm planning on upgrading the two 5508s to the require IRCM images and then looking to build a mobility tunnel between t...
What are the actual differences or advantages/disadvantages of doing one over the other? thanks!
- Informational : https://mrncciew.com/2022/07/11/cisco-9100-ap-as-wgb/ M.
Our WLC running on 8.5.171(recently upgraded) with 1852 AP's every four or five hours my AP's are disconnecting from the controller for unknown reason, Switchport is up, AP uptime is good, so the AP is not rebooting, but AP couldn't able to join the ...
