Wireless

Hi Guys, i am getting lot of issues for Cisco APs of model AIR-AP3802I-Z-K9 for DTLS connection issues. *osapiBsnTimer: XX 0X 09:22:38.271: %DTLS-3-HANDSHAKE_FAILURE: openssl_dtls.c:3191 Failed to complete DTLS handshake with peer X.X.X.X Anything kn...

Cisco 2500 WLC Alexa smart home connected but not working do in need to enable any service in controller please help me 

Hi,Some devices do not see  some ssid SSID,(The SSID is running both 2.4 and 5 Ghz).I have three SSID , sometimes the device cannot see the SSID intended to connect what could be the issue Thanks 

Hi, after a power failure, a lot of our 3502i would not reconnect to the controller.Has taken factory reset, but receives the following error messages:*Mar 1 00:14:00.475: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 255.255.255.255 port 0 CLI Reque...

Hi all,I am facing an issue since few days. The access point gets disconnected automatically and gets connected again after some time. when I checked the logs then I have found in the logs..  kernel: DOT11_DRV[0]: Channel set to 11, width 20 kernel: ...

Hey All, Looking for some quick help here, I have a 9130i that we were testing the embedded WLC functionality on.  However, we have decided not to continue down this path and want to revert the 9130 back to it's original state, essentially removing t...

WLC 5520 now running 8.10.162.0  (upgrade from 8.5.140.0)  I've noticed two new fields on the WLC AAA tabBoth of the new fields show as ACA server.  I've looked at the WLC help files, and documentation for the release, and searched the web for inform...

i have wap371, but i setup and connect to modem wifi, it can not internet , an not connectev

Greetings,i need to ask about what is the ability to create high availability between cisco wireless controllers physical and virtualit's possabile or notthanks 

Hello everyone,I am facing this problem: I need to connect the Cisco AP as autonomous Wi-Fi bridge extender ap. I can’t deactivate my soho ap (Airrus) as its ethernet port linked to the Cisco ap is limited to 100mbps, while the soho ap runs at 250mbp...

Hello! I see the installation guide has very clear instructions for generic KVM and ESX environments. Is it worth while adapting these instructions to install on Nutanix, or will it not work? Many thanks ion advance.