Hi all,when running mobility express on AP 3802i acting as wlc with image 8.10.151.0 , it appears the option to enable/ disable the led status has been removed from the cli wlc-ap#wlc-ap#config ap ?auxiliary-client Configure auxiliary-client interfac...
Forum Posts
we have WLC 5508 S.W ver 7.6.110.0 . Field Recovery Image Version 7.6.95.16.recently system is hung up and stop working and APs are disappeared. we can't do any thing until we power off WLC and power on it . Sys led is blinking amber and ALM ls is o...
Just can't change radio parameters of RF Channel Assignment, Tx Power Level Assignment , all the option are grayed on the 9800 WLC, within Configuration -> Wireless -> Access Point -> 2.4/5.0 ; is there a way change this? I just want to change de va...
running the 17.3.3 code now. From what I can tell, upgrading to 17.6.x code it will not work with IOS based AP's according to the tech notes. We are currently using AIR-CAP2702I-B-K9 on the WLC now. Do these fall into the "IOS based" category.? I d...
Resolved! error in save in access control for SSID
Hi, community In dashboard, I have not been able to make changes in the SSID preferences. This image to show my error. Thank's your collaboration
Hello, I have assigned a fixed IP address to my 140AC access point during the initial setup.Now i want to change this IP address, but unfortunately i find no function in the GUI to do so. The only thing i can do in the moment is, to set the device to...
Good day I have been having an issue with the connectivity of iPads which are attached to forklift trucks driving around production plants. The users have been reporting regular disconnects and it has been taking several minutes for them to reconnect...
Hi All, I was trying to convert Cisco 1562i WAP from light wieght to autonoumus using the command"ap-type mobility-express tftp://192.168.100.117/AIR-AP1560-K9-ME-8-10-162-0.tar" but its failling in the end with below error, any help? + loudlog Imag...
HiWell, the "BAD_ADDRESS situation" is a classic when it comes to Cisco Wireless Controllers.We're also seeing this on the Catalyst 9800 platform. On the 550x platform we could issue the command “config ap dhcp release-override” to solve the problem....
Platform family -- CiscoPlatform details -- Cisco WLCPlugin name -- 1. SSL Certificate Signed using Weak Hashing Algorithm 2. SSL Certificate Cannot Be TrustedPort -- 16113Protocol -- tcp Above is the vulner...
I'm just learning the new Cisco EWC lingo on a Cisco 9120AX. Got over the initial shock of Policies and Tags and think I have a good handle on it. But my situation now is that my WLAN configured for vlan 1 will not drop the client on vlan 1, but dr...
Hi I think its possible to configure Cisco 3702 ?*(Autonomous AP) in WGP (Workgroup Bridge) mode connecting to ISP router (Non-Cisco) router? it works fine on Workgroup Bridge Universal mode but problem is I can connect only 1 device. In workgroup mo...
I have a dead 1832 Access Point, from a lightning strike. Is it possible to just replace the power supply?;)
Everything has been working ok until today. Today I factory defaulted and reconfigured my 9800 in my lab and now the Licensing > General tab shows "No Licenses in use" My single AP is active and clients are associating. My understanding was that li...
Good morning, My site has been Meraki and trouble-free for 5 years but recently we have had to restart AP's left, right and center to combat slow speeds and connectivity issues. This morning I have noticed many AP's have "ARP failures" but am struggl...
