We are running into an issue where the following command does not appear to work:
RP/0/RSP0/CPU0:9006-Spare#sh tech-support terminal ^% Invalid input detected at '^' marker.RP/0/RSP0/CPU0:9006-Spare#sh tech-s...
Hello,
I am trying to find out If and when there will be support for
BGP EVPNNETCONF for B-MAC Filtering
Also if there is some roadmap of releases or something that will be also useful.
Thank you,
Andrej
Good afternoon
Today I attempted to configure the following on an ASR 9010 in our network:
- snmp-server ifindex persist- snmp-server mibs cbqosmib persist- flow exporter-map SOLARWINDS-IPV4- transport udp 2055- source Loopback0- destination 1.1.1....
How can I limit the number of session per user in the IOS XR 4.3.2, i want to limit to five sessions per user? the equipment works with an Tacacs+ server.
RP/0/RSP0/CPU0:EDGE1#whoThu Jul 14 11:54:05.006 MEXICO Line User ...
Hi Expert, As I understood, the advantage for using Turboboot upgrade.1.Most Clean Installation: TURBOBOOT,we can format installation disk and install XR system in it.2.Min Service Impact: Install Mode, Install .pie packet3.Most of Users choose PIE ...
Hi guys,
We have an ASR 9006 configured as a BNG. I wanna run ISG on this router. Is different ISG configuration and normal BNG configuration on ASR9006 or not?
Is there any documents about ISG configuration on ASR 9000?
Regards.
Hi,
IOS and IOS-XE devices have the scope of configuring http client on a device.
Would it be possible to configure the same on a IOS-XR device?
If all devices that run IOS-XR dont have support for http client, which are the ones that do?
Any help in...
Hi there,
we currently have a ASR9K with 5.2.2 + SP and want to know do we need to deactivate the 5.2.2 SP1 first before activating the 5.3.3 Pies?
Active Packages: disk0:asr9k-doc-px-5.2.2 disk0:asr9k-k9sec-px-5.2.2 disk0:asr9k-mini-px-5.2.2 disk0...
Hi,
I have the following Class of Service and I need to mark the incoming traffic to "0" in order to put the traffic en Bronce queue. The platform is ASR9010 and the line card is A9K-MPA-4X10GE.
Class of Service Precedence
Real Time ...
Following a reload, a ASR 9001 boots up it has lost all of its config and gives the error below:cfgmgr-rp[160]: %MGBL-CONFIG-0-INIT_FAILURE : Configuration Manager was unable to initialize the Configuration Namespace Version History module. Error: 'R...
Hello all,
I have used the below EEM script on a Cisco 3750G running IOS Version 15.0(2)SE to capture the logs when CPU spikes that help in the investigation of the reason for intermittent CPU spikes. But I saw that the logs are not being captured in...
Hello All,
We discovered a waring in show hsrp trace as follows.
Jun 23 06:46:29.805 hsrp_unbulk 0/RSP0/CPU0 t1 Failed to receive packet: 'hsrp' detected the 'warning' condition 'Packet too long'
After somme investigations we reproduced the pr...
Hi
I need some help to clarify my understanding about two items on ASR9k.
Platform is ASR9904 RSP400 running 5.3.3
I have traffic on the interface below as vlan tagged or untagged for which I want to setup l2vpn xconnect to another port (G1/0/0/4)
Is...
Hi,
I'd be grateful if somebody could recommend me a software to collect CGNAT logs with Netflowv9 format. I don't know if I can use traditional Netflow collection and analysis solutions like PRTG, sw from Caida, etc., or I need something more speci...