i tested the DNAC Device PNP Onboarding Process for IOS-XE, Below is the full procedure and also claimimg the device.https://www.thenetworkdna.com/2021/06/dnac-device-pnp-onboarding-process-for.html
Hi, At the moment we're planning to subscribe to events when APs becomes unreachable, using webhooks for monitoring purposes. Is there any way to get events for when an AP is reachable again? If not, what's the most reliable endpoint to query? The ra...
We are planning to upgrade our C9300 switch which are connected to the routers going to the internet. Current version is 16.6.4. We need to upgrade to 17.3.3. Since it has redundant etherchannel connections going to FW and Internet routers we expect ...
Hi I am trying to provision 2 template on a device, and one of the templates does not get deployed and I get an error.The other template is deployed successfully.I have tried to login with the user that DNAC uses and I can past the commands in withou...
Hi All, I can see there is a new API "Cisco DNA Center Release Summary" in version 2.2.2 which should return API version, mandatory core packages for installation or upgrade, optional packages, Cisco DNA Center name and version, supported direct upda...
Hi, I have an issue when trying to import dwg floor plans in DNA center GUI. DNA center displays a blank image when loading the file, even though other tools (such as Visio) can open the file correctly. See attached screenshot. This is happening on D...
We ran into a strangle problem.1. Our DNAC is inside of ACI fabric and is managing number of Cisco switches and WLC outside of Fabric through L3Out.2. We powered cycle the DNAC and all of sudden ACI registered those Cisco switches and WLC managed by...
login page doesn't show up after reimaging it to 2.1.2.6 successfully with USB, error message says "{"message":"no route and no API found with those values"}", tried to reimage twice and facing same issue, did any one seen this issue?
I get this error when trying to install switch using our DNA center PnP Discovery stopped (config text) I Can Ping our server - so i Think the problem is on the switch
Dear All, Hope you are well. For a customer of ours we are trying to automate the task of assigning IP Pools to VNs.I am using this api dna/intent/api/v1/business/sda/virtualnetwork/ippool and it works fine with all other VNs. However, when I try to ...
I am not finding this information anywhere but what are the specific ports that are required for cluster communication within DNA Center? I checked the ports that are listening on the servers themselves but am not able to tie those back to any docume...
Hican anyone advise the two /21 subnets reuqired for services subnet and cluster services subnet are these addresses just used locally within DNA itself or do these ranges need to be routable and reachable.??? Thanks
Hi, We are on the process of enabling Stealthwatch on our network and one of the requirements is to configure netflow on the devices. Is there a way to configure netflow via DNA Center? I tried to enable it via telemetry on DNA Center but it seems ...
Dear All, we've below BOM and want to use ISE, Prime Infrastructure and other services included in DNA premier but we want to make sure what additional components must be added to use those features and what exact features or services do we have apar...
