Cisco Catalyst Center

Hello everyone,When I import a new image into DNA Center then assign it to a device family that's not already created, nothing happens.I was expecting to see a new family created, so I can use the image during pnp.Does anyone know how to solve this p...

It is possible to change the automatic compliance scan from Saturday at midnight to some other time?  I have a programmed maintenance window in my FW that is at a different time during the week.  I have not been able to get my EoX scans to complete e...

HiWe've got a deployment running version 2.3.3.7 on a single node, I recently enabled event notifications for a variety of things, AP disconnections, OSPF flaps etc. However I only seem to receive these alerts when the issue is marked as resolved, ra...

Hi all, Is there a way to clear the Inventory Insights in DNAC? Can this be done through either the (CLI) or  (GUI)? I've received incorrect alerts on version 2.3.3.6-70045 and I'm looking a method to remove them.

Hey all, I just want to know what the difference between the DNAC subscription (L-DNAC-MGMT-ADD) and the DNA Virtual Appliance (DN-SW-APL) is? What are the use cases for each? Please, provide me with resources! Thanks

Hey all, I just want to order Cisco DNA Center Virtual Appliance. Simply via CCW I ordered DN-SW-APL and I found that there are two options: DNA-SW-AMI and DNA-SW-OVA I need to know how to differentiate between the two and which one is the most suita...

Hello, how can I configure a port on an edge node in sda fabric which is from a "layer 2 only" pool using the API?In the GUI it's possible to choose data vlans which originates from "ip address pool" or from a "layer-2-only network". Using the API I ...

I have 3 nodes, and two nodes have faulty parts.Node 2 requires an SSD and Node 3 requires memory.I cannot seem to find information about how to go about replacing these parts and in which order.https://www.cisco.com/c/en/us/td/docs/cloud-systems-man...

Hi, everyone I understand that the WLC cannot be used without adding it to the dnac factory, the possible solution would be to install an independent wlc with its respective AP to provide wireless?If you do not have a WLC, can you install only the AP...

Hey,So I'm struggling a bit with finding the correct AP sometimes, when the name might be unavailable to me, but I have the wired ethernet mac address.In inventory I can search by mac, but thats the radio mac - what gives?I think its quite inconsiste...