Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Friday, June 21, 2024 through Friday, July 12, 2024. Our colleagues Saurabh Khillare, and Absar UI Farooq will be waiting to assist you ...
Forum Posts
Hello, which is the MTBF for Ethernet modules NIM ES2-4 or NIM ES2-8 ?Thanks in advance MTBF, NIM ES2-4
Hello everyone,In the near future, we will be deploying a physical 32-core Catalyst Center appliance in a customer network for the first time.After reading both the Third-Generation Appliance Installation Guide and the User Guide (both release 2.3.7 ...
Hello guys. I'm trying to perform a POST Rest API toward Cisco DNAC (Catalyst Center). The body it's like that: [ { "name": "Pool-1", "type": "Generic", "ipv4GlobalPool": "10.0.0.0/8", "ipv4PrefixLength": 2...
Resolved! Q in Q decapsulation
Hello, When the double tag frame reaches the destination switch in the 802.1q tunnel, where does it begin to decapsulate the outer tag of the frame as it reaches the end of the tunnel? Does it start at the ingress switchport trunk, or the egress swit...
Hello there, I would like to know how are the different ways to onboard a border node to the DNAC, I mean the way that the device will be added on the inventory, not how it is added to the fabric. For me there are basically 2 ways : - manually config...
Dear friends,I hope anyone can help with this issue:I need to capture the packet traffic for one of the interfaces of a 2960 using the EPC utility. The switch has the following hardware / software: WS-C2960CX-8TC-L, 15.2(4)E6, C2960CX-UNIVERSALK9-MSe...
Hi,I would like to retrieve the details of the networking devices (switch) connected to the access points in Catalyst center.I am using the version 2.3.7.5I can generate a report for all the network devices like swithces and access pointsBut it would...
We run a 3rd party netflow collector, NtopNG with nProbe.Our switches were running a netflow template we have had for years. I decided to wipe it and allow Catalyst Centre to input its own netflow config so I can also get some app info in Catalyst Ce...
Is there a way of configuring DNA Center to either send an email or some sort of alert when certificates are about to expire.?
I read tool use aura for enhanced visibility into the dna center.But I try run but cannot run. Please help me or give me link tutor to run for tool
После обновления, не работает Web Interface и Vlan не ходят, кроме Vlan 1.Начал настраивать Trunk порты, настроил, прописал Vlan 11, Vlan 12 на одном trunk порте, а на входящем порте прописал Vlan 1,11,12. Работает только Vlan 1, а Vlan 11 и 12 не ра...
I was notified from Cisco that my C9300 DNA Essentials is about to expire. Product number C9300-DNA-E-48=.We're a small shop, and if I recall correctly, we were required to purchase DNA with the switch as a mandated SKU. If I understand correctly, "D...
Been struggling with DNAC compliance reporting with ACLs. I have a basic sample ACL that deploys successfully but the compliance in DNAC flags the entire ACL ac non-compliant. I can see the ACL in the config on the switch and in the configuration in ...
our DNAC_Aura reports 2 Catalyst 9k switches in Bundle mode. Any tips to find which of these 9K switchs are in bundle mode using Cisco DNA ?
