Hello, we have installed catalyst center in air gap mode and wish to verify it. I thought that only air gap installations have an "eula..."file and can verify it this way. But maybe there are better solutions. Kind regards, Daniel
Hi! I'm looking badly for Cisco Catalyst WS-C2960-8TC-L firmware.Corrupted one was c2960-lanbasek9-mz.122.50.se4Can you share it for me?Peter
Hello Community,I want to know any reference ( not to be stuck in theoritical parts to understand SDA ), to migrate from a Traditional Network to a Fabric Network. As in any document having SDA Deployement Process, or should I connect with the TAC En...
Hi all, we're attempting to upgrade our 9300 series switches but wondering what is the correct IOS bin for the C9300-48U model?https://software.cisco.com/download/home/286313806NAME: "Switch 1", DESCR: "C9300-48U"PID: C9300-48U , VID: V06 , ...
configuration to use external AD login has been configured.When enable external user is checked and a login attempt is made using AD account, it fails with invalid credentials. ISE tacacs live logs show a successful authentication and authorisation. ...
im trying to configure my switch, i got the initial part done, however tying to get the24 ports on 1 vlan i type the following command "interface range" reports back as incomplete command.typed interface ?and it shows that "range" is an acceptable co...
Hi, I need to edit this ACL DNAC_ACL_WEBAUTH_REDIRECT created automatic by the DNAC Server. How can i edit this? At my controller side or at the DNAC?
I feel this is a fundamental question, but i need to ask as a newbie here. I have been trying to figure out how to edit a switch configuration once it has been discovered and onboarded into DNA Center. Command Runner won't let me use any command to...
Hello, will there be an increase in the maximal amount of device credentials in the future? Cisco did not do anything after publishing this: increase maximum credential count 10 -> 200 CSCwh60626 Regards, Daniel
I have a Cisco Catalyst Center in my DMZ. The Enterprise and Management Ports are all connected and allowed through my internal FW. The Cloud Port is connected to my external FW. Can I use NAT on the external FW to the Cloud Port on the Catalysts Cen...
Hello All, I am using cisco c9200 catalyst, I have traffic in this router 20000 frame/second and my bandwidth can handle 12500 frame/second my frames are 1000bytes, I am seeing almost 0.1s for end-to-end delay and 37.5% as loss. i expect to see chang...
I have 2 Cisco DNAC Appliance that I went to deploy it in Disaster Recovery Mode.In my use case, I don't have all Prerequisite as below :I only have 2 sites, the questions where I have to install the witness VM ?I don't have 1 G between the 2 sites....
Hi,I am trying to bulk import devices from a csv file with site name that contains a comma.I have tried to enclose the site name in both single and double quotes, but dnac still complains, and splits the site name into site and RF-Profile. What is th...
Hi, I would like to check if the following is supported by Catalyst Center, 1. Be a NetFlow Server? 2. Integrate NetFlow solution like Solarwinds NetFlow (NTA) or Stealthwatch solution? 3. If item 2 is possible, what can be done once integrated? Only...
I've been trying to get the initial installation completed for Cisco DNA. I have been finding an inconsistency in documentation official and unofficial. Currently I'm in the process of running through the Maglev Configuration Wizard and am having is...
