Data Center Switches

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

HiI have one Nexus 5696q and some 3850 & 2960 switches. 3850(2960x) Switches connect to Nexus 5k via Fiber Cables. When i Configure Ether Channel between Nexus 5k and any of 3850 Switches i get "High error rate" error on port channels in Nexus 5k and...

niki1365 by Level 1
  • 1361 Views
  • 0 replies
  • 5 Helpful votes

Hi Experts,I have nexus 7706 series swithc and created 2 vdc on it,there is no routing between VDC.i configured a mgmt ip on all 3 vdc in same subnet.i can ping my default gateway from all VDC but i can not ping my admin vdc mgmt ip from any vdc.admi...

kkp1 by Level 1
  • 1055 Views
  • 0 replies
  • 0 Helpful votes

I have been trying to boot the N9kv in VMware following the steps in NX-OSv 9000 for in the section for VMware "Provisioning the NX-OSv 9000 in the ESXi Hypervisor, for the most part the description is very similar to what we can configure but I'm ha...

Greetings, I am looking for suggestions on multitenancy options for a small DC, the design is VRF heavy (about 400-500).  The hardware setup is simple, Agg/ToR using the Nexus 3232c.  I am trying to keep the VLANs in the ToR and route between the Agg...

I am looking for a solution to monitor east/west traffic in our data center. Currently we have 2 Nexus 5596 which do not support netflow.  Is there a recommended solution or network sensor that I could add onto the 5k and span the traffic? We have a ...

Nick C. by Level 1
  • 5677 Views
  • 6 replies
  • 1 Helpful votes

Hello,On a nexus switch when i run the command "show int capability", it shows "Pvlan Trunk capable:   no". Does this mean the interface is not capable of being used as a trunk interface to carry Private VLAN tagged traffic.I have two switches conenc...

mjt by Level 1
  • 1000 Views
  • 0 replies
  • 0 Helpful votes