IP Telephony and Phones

I recently installed a new CP-8831 with two wireless microphones.  Everything works perfect except that callers on the other end report that it is hard to hear me until I literally hold one of the wireless microphones up in front of my mouth.  Is the...

I have installed Cisco CUEAC 9.1. In User Configuration mode then in Queue MGMT option, i am unable to find Queue DDI option like as in previous version 8.6. We have following options.1. Name 2. Queue DDI3. Priority4. Saluation But in 9.1 version, we...

Hi,I have installed Cisco CUEAC 9.1, everything synced except DDI but Queue DDI option is not available. I tried to use Name as DDI but didn't work. But in Version 8.6 we have DDI Queue option right under Name option. I need support on this issue urg...

HI, can any body tell me about what is PVDM3 and what are no. of port on pvdm3 and what kind of port on PVDM3also keen to know what is the purpose of SRST license how 2911 router act as a voice agteway regardsrajat

Hi everybody! In near future our company is going to subscribe to SIP services, but i'm not sure how it will work through ASA firewall. I heard that NAT causes problems for sip telephony. What kind of minimum configurations should i make on ASA to al...

Dear All, Is there a restriction in creating an intercluster trunk between 2 call managers. I'm trying to simulate this in a lab environment where i have one Call manager version 10.5 connecting to a Call Manager 7.1.X to route some calls outside my ...

We have just been assigned a new PRI to which the telco has redirected two old numbers (fax and main switchboard) from a previous office.For sake of the discussion, range of DID's on new PRI is 1231000-1231099 (100 numbers), old fax is 1238888, old s...

Hi Experts,i am usingcucm version - 10.0.1.12900-2Presence server - 10.0.1.11901-2Jabber for window - 10.5.0cisco ip phone - dx650when i try to make a call to dx650 from window's for jabber video  - point to point calling is happingbut when i try to ...

I have a 7962 with a 7914 attached.  The speed dials work, but the BLFs don't show the status of the in use line with a light.  On both the phone and the sidecar, the symbols are 4 little squares instead of phones like you would normally see.  I have...

Hi everybody!I have some problems with my IVR and my incoming calls.First, I will give you some information about my devices and system and then I'll explain the issues.I have 5 IP Phones, model cisco CP-6941.I have set up an IVR which plays a record...

Hello everybody!I need to set Busy Trigger parametar to 1 for all the phones in CUCM.I know how to do that for one phone in Line settings.But how to do that for all devices? 

Dear All Experts; i want to register phone via SIP from outside office over internet. currently we are using cucm 9.1.x and all phones are registered with SCCP. I have a plan to use office phone from home using SIP over internet. please tell me simpl...