IP Telephony and Phones

Hello, we use a CUBE between Provider and CUCM.Within incomming Invites we received the "Blocknumer without DDI" in the Header and the Number with DDI in the TO: Address.The outgoing Dial-peer matches and send the Call to CUCM but only with the Block...

Hi,We have various model of ip phone in our production network, and each model, with different phone load although same model. For e.g.:CISCO 7911, we have 8.3.2S, 9.0.3S existing in the production network.I used RTMT to filter the out-dated (prior t...

Hello!I am connecting Some analoge phones to VG350 FXS ports which is  configured as a MGCP Gateway in CUCM. I beleive MGCP did not requires any license for it. Can some confirm this ? is there any Cisco doc on it ?Thanks & Regards,

HiWe have an issue with calls from PSTN. When we received a call from PSTN the caller hears an IVR and then press the option "2" then the caller should be transfered to extension 96537, that is another IVR, but the caller hears ringback and then the ...

Hi There,I have noticed when running a 'show call active voice brief ' that at the top there are calls from over 5months ago in the logs. I thought that this command only shows active calls, so am a little confused as now I am not sure I can trust th...

Hey Guys!Whats happening with my CME??? Analog lines went dead after an electric outage!! Feb 21 15:26:55.663 EKT: %DSPRM-5-UPDOWN: DSP 1 in slot 0, changed state to upFeb 21 15:26:57.055 EKT: %DSPRM-5-UPDOWN: DSP 2 in slot 0, changed state to upFeb...

Hello,help me pls analyze the log. I cant perform call from 1991(Avaya phone) to 1225(Cisco 6921 SIP phone). When i call from cisco to avaya everything is ok.CME 9.5. Avaya and Cisco connected over H.323. P.S. Or did i need to use SIP trunk - "SIP en...

Hi Team,.Can you please assist me to have the latest version of the CUCM IM and Presence Service (v9.1) shipped to me on physical media for first time installation?When I go to PUT tool it only ask me for the upgrade but I need it for the first time ...

Should I set the bandwidth on my priority queuing policy?  This is on a Nexus 5548policy-map type queuing EGRESS-QUEUE     class type queuing VOICE_VIDEO      priority      bandwidth percent 30     class type queuing SIGNALING_CRITICAL_DATA      band...

Good evening everybody,I'm facing an issue when calling from a mobile (SNR) using CLIR. CUCM is replying with a 404 Not Found. I have gathered logs and I have found that when CM is looking for the RDP, removes the "+" digit from PAI:SIP/SIPHandler/cc...

I added a new site in columbia and change the user local to  spanish, columbia.reset the phone, but it still come up as english.ccm:  7.1.5thanks

hi,If I use the template for 2500 users, and my cluster with 9 cucm servers, with only 4 of them have callmanager service, does it mean that i can have 2500 x 4  = 10000 phones in my cluster?I am wondering if we can deploy different capacity of cucm ...

Hi ,I have two clusters both running 8.6.2aAt one site i have Arc Console v 5.1.4We are trying to transfer using the operator console across to the other cluster using  and ICT (SIP) to a standard cisco phone.The call is placed and rings with no dela...