Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi all,Have a request from a client to be able to have two active callers on two seperate lines on their phone and have some way of creating an ad-hoc style conference with themselves included.Similar to a Join but both callers are connected on diffe...
Hi ,I have set-up a intercluster trunk with Gatekeeper controlled but my problem is that on the trunk configuration in the Call Manager , you need to specify the location of the trunk so that ( what I think) before to send the call to the gatekeeper ...
Hi,I have CCM 4.1(3).I need to use Softphone over VPN.Checkpoint firewall version is R55 and R65.Need help about how to use softphone over Checkpoint VPN.Please suggest.
I have a new bundled SRST box and I`ve configured ccm-manager fallback etc and the mgcp. Sh ccm-manager shows it is registered and I`ve configured some FXS ports -all good but when I try to create the E1 controller I can not do it- Try to set up th...
I need to change the default packetsize on all 7906 and 7911 IP phones. Can anyone help me?thanks in advance Olivier
Hello!We have deployed VoIP 2 years ago. It is CCME 3.1 based on 2811 router and 34 phones - 7912G. Now we want to expand the number of phones, so what solution we need to minimize migration tasks and keep old (34 ) phones in use?I see this solving:C...
Hi,I have a CME with 7906 and 7911 IP phone and the MOH is not working ???Here is my CME config in attached file.Thanks in advanceOlivier
hello experts, i have two sites, each one is connected to the internet by ADSL connection, so can i perform voice over ip solution over this internet link
Hi at all,I would like to configure multiple sip trunk on cme 4. There is any way to this?Thanks, Bye!
Hi,If an admin forget the CCMAdministrator password in MLA enabled Callmanager how he can login
Hello,I use Call Manager and have a voice gateway. They are relyed by SIP trunk.So When I call from the Call Manager to external call, there are an IVR in the called number.So i have to put many digit. But the problem is that I cannot put the digit. ...
Turning up some new LD outbound only T-1's. A call that uses these T-1's is not sending CID information. We have the external number mask setup on the DN, which worked fine before with the PRI. I have seen some comments regarding caller-id with certa...
Hi, i have a cluster of callmanagers 5.1 on a local site there are also some remote sites where are some ip phones. There is one site that has 600 ms of delay and the phone that is there is getting unregistered each certain time.Do you know if i can ...
I've a 2811 router with one VIC2-2FXO card install, running c2800nm-advipservicesk9-mz.124-6.T6.bin IOS.The configuration:voice-port 0/1/0 echo-cancel coverage 24 no comfort-noise connection plar 5028dial-peer voice 3 pots preference 1 destination-pa...
I am having issues getting ports registered with CMv6.01. On the VG248 I get this error message on port 1.SCCP 1 "Registration failed: Error: DB Config"Anyone have any ideas. I do not have auto registration enabled in CM and I manually configured the...
