MPLS

Hi,I'm attempting to adapt a scenario from the MPLS and VPN Architecture CCIP edition book.  The scenario that I'm working with has two PE/P IOS XR routers in a collapsed MPLS core.  All customers are terminated in their own VRF on each PE/P router. ...

Dear all,I have the following Network; I have 3 routers are  running L2TP V3 (R2,R2,R3) one HUB and 2 Remotes  to carry MPLS traffic from MPLS Routers (R4,R5,R6) as diagram shows I have attached the configurations of MPLS routers:When I issue this co...

Hi, What is the difference between the 2 commands given in the subject line..?I guess both are basically used for binding the attachment circuits to VC in a VPWS scenario..?Thanks in advance..

HiI do not understand about 'mpls tunnel traffic-en bandwidth'If i want to use the RSVP-TE then i know i have to configure the 'ip rsvp bandwidth ...'  and 'tunnel mpls traffic-en bandwidth...'But why i have to configure them for TE.RSVP is Resource ...

I have trouble connecting a Level3 DIA (Dedicated Internet Access) to my 3560 switch. It works fine if I connect it directy to the outside interface of my ASA5540. Since I have a single internet handoff I need to connect it to a switch in order to im...

Hi, In our MPLS network we are planning two add one more WAN link between two nodes of same bw as of existing link, say two WAN link of 200Mbps. As a IGP we are running OSPF and MPLS enabled on the WAN. If the traffic gets load balance on both the pa...

please can anybody send me a working configuration on GNS3 for this issue(MPLS with Static Route) i couldn't make it working , so if somebody has the configuration with the topology please send it to me ,,,, thanks in advanced for your cooporation ,,...

Hi,I am working the EVN design  but i am facing problem in the route replication (router leaking in VRF). I also read some cisco docs but did not get theresult. Kindly look at below config and correct if there is any improper configany example for EV...

Hello All,I am trying to implement a conditional advertisement with (neighbor advertised-map statement) under  vpnv4 address-family, to control the exchange of vpnv4 prefixes, but this seems to be impossible. I could not get an advertised-map command...

Is it possible to leak public IP from a VRF and PE-ASBR will announced the IP to Internet by eBGP?

The scenario is that we will be "Wholesaling" Circuits from other carriers. All will map to a centralized Router running a VRF per customer. The question is, how do I know how to size the router appropriately?How many VRF's can I have,What would be t...

Dear Friends,can you please tell me why we need MPLS in the network? and what are the advatanges? which specific services can MPLS provide and can not possible without MPLS?thanks

Hi Guys,I'm naive in terms of knowing MPLS, but want to know one thing. I'm going to take up a task to configure MPLS networks between sites, where the Service provider has already setup their part. So my questions are1). As a customer what needs to ...