MPLS

Not 100% sure I have my category right but I am trying to figure out what exactly att IPDSL is. I'm familiar with adsl and vdsl. So what is IPDSL. My company is slowly upgrading there locations to IPDSL via a partnership with att so I am trying to re...

Hello, I want to test/deploy MPLS on top of our current L3 network, but i do not want our current global routing table to be label-switched (which is the default behaviour).This should be possible if i deploy new dedicated Loopbacks for MPLS connecti...

DearsDoes ES+ cards supported If SUP-2T is installed on 7600 routers ? Many Thanks

Hello,I have a network based on ME-3800-XI use MPLS/Vpls technologie and too VRF/MPLSThe VPLS works but at times, there has @mac flapping between tunnel EoMPLS of VPLS.For exemple :Oct 13 05:52:46: %SW_MATM-4-MACFLAP_NOTIF: Host 0016.177b.17e1 in vla...

Hi,we intend to deploy a centralized BRAS solution in our network using 7600 routers, where the ADSL users are bridged through VPLS instance to two remote PE peers where the Centralised BRAS is attached, all the users will be received on many service...

I cannot find any information about MRU parameter except the book "Mpls fundamentals" where there is some explanation about sense of this parameter however it is not clear enough. Can somebody explain me how it works? I cannot understand whether MRU ...

Hello,how is it possible that VRF can be routed from one site to another site by the core routers?It is clear that the VRF must be configured and each interface is to be assigned.In addition, the IGP / redistribution between PE-CE and MP-BGP is to be...

hi,can i get combined speed from two different isp 's?for ex: isp1 2mbps + isp2  4mbps  = 6 mbps speed.

Hello,I have this setup:PE1 router is connected to P1 router via single 1G Intf. P1 router is in turn connected to the P2 router via 8xSTM-1, and finally P2 is connected to PE2 via single 1G IntfPE1--P1==P2--PE2Now, this is how PE1 is seeing P1's MPL...

Hi,  I need help, I have a core MPLS made by four devices. They are ASR 9006, everything works perfect, lately we installed a client that need redundancy so I configure two BGP session on my internet VRF, the problem is that I assigned to the client ...

Hello All,I am new to Cisco routers and MPLS too. Can someone please guide me to few links to understand MPLS.Basically I am looking for MPLS-VPN understanding. I need to implement the and troubleshoot in my current role.Thanks,

We are deploying a backup data center and need to extend couple of Vlans over the backup data center.These two DC's which are interconnected by a fibre link which we manage and terminates on the ODC2MAN and ODCXMAN.We run  MPLS on these devices ODC2M...