Hi friend,I have a problem with cisco network assistant to manager a WS-C4506 which has a cat4500-ipbasek9-mz.122-54.SG1.bin IOS version. The cna dont find this device.Thank.Marco.
Hello,I have a Cisco LMS 4.2.1 on a Windows 2008 Server R2 plateform and I would like to bakcup the configuration of my WS-C4503-E version cat4500e-universalk9.SPA.03.03.01.SG.151-1.SG1I create the job in Configuration > Configuration Archive > Synch...
Hi,I have a NPEG2 router running 12.4 (15) T12. There is a channelized E1 card (PA-MC-8TE1) inserted into the router. One port is configured for channelized time slots and remaining interfaces are configured for full line rate i.e. 2Mbps.While doing ...
I started to train seriously in my lab, preparing CCNA exam, yesterday I played with the ACL, I configured to deny ICMP traffic, but I've tried to set it to default www and ssh, but it did not succeed, I have a 1841 router with 2 host connected, the ...
I am Setting up a mail server in EEM to receive ena Email , iam receiving the following :smtp_write AUTH LOGIN Y29ycHByaW50smtp_read 504 5.7.4 Unrecognized authentication typethe config :-----------------------event manager environment _mail_rcpt use...
Hi All,i have a problem of syslog with my LMS 4.2. In fact,after rebooting the server, i can't find in the report the old logs recived from the devices.Please note that the logs from equipements are present under NMSRoot\\CSCOpx\log, syslog fileAttac...
Hi,Customer likes to migrate from lms 3.2 to lms 4.1. Current lms 3.1 runs on solaris. New installation shut run on windows.They would like to setup the windows server with new ip and name. After the new lms 4.1 is running, customer would like to shu...
I am not quite sure how this happened or as to why.I was logged into our ASA 5505 via ASDM-IDM Launcher (everything was working) and when I tried to update a change later on today it was unable to send the request. I tried to ping the device and the ...
I have about 500 devices in my LMS4.2.2 and they are all managed by Hostname/DNS name. when I go look at the raw syslog file (tail -f syslog_info) I see most of the devices (more than half) sending syslog mesaages by their IP address instead Thus do...
I'm currently using a LMS 4.2.x System and an ACS 5.3 System.I solved the problem to authenticate the LMS WebGUI login to the ACS Server. But, I can't not find any document, which descripes how I can assing the group roles via ACS.Kind regards
Well, I have been getting weird call loops on one of my CUBE's and instead of me being up until 2am waiting for the occurence to happen I would rather have a script run since it is like clockwork. My coworker told me about EEM and I have been dabbli...
Hi Cisco Community,I need help and advise.I have an issue with Cisco 3560V2-24-PS which it indicates not supported in DFM. I can see the device working properly when I do snmpwalk and snmv3 test and device credential test. In fact I can see chassis v...
We are using non-advertised IPs on many devices, but LMS is attempting to ping these addresses and setting off all sorts of security alarms. Anyone know how to stop LMS 4.1 from pinging the interfaces? We don't even want LMS to do any fault monitor...
