Network Management

HiWe have several unknown devices in the DCR.  I know the correct package is installed because we have an identical device which has been identified correctly i.e "Cisco 3750 stack".The SNMP credentials are correct as I am able to do an snmpwalk -v 2...

Hi,     When i am configuring IPM 4.1 for udp jitter operation. i am getting the error message as "Only responder enabled devices permitted for selected operations" , but i have configured the "ip sla monitor responder" command both in source and tar...

Re: How to configure configuration backup in CiscoWorksGo to RME - Admin - Config Management From there you can edit your Transport, Archive and Collection Settings. Once this is done everything should be setup for config collection.hey, i am trying ...

I am setting up some trapping to our Net mgmt station from ourCisco devices.  There sure are a lot of trap options that can be configured on the Cisco Swiches and routers.I wondered if there was a de facto list anywhere that anyone has devised for a ...

Hi, group.Can I utilize MRTG to graph Top n only out of thousands of switch ports? thanks.Leo

We have several CSS devices that are configured to send logs to our CiscoWorks server.  The CSSs are also configured to log to another syslog system.  We can see log entries for the devices at the other syslog server, but not the CiscoWorks server. I...

Hi ALLI am trying to deploy new passwords from cisco works server -But am getting the following problem -ERROR:RME_CDL1031:Transport session to device failed TFTP: failedCould not detect protocols running on the deviceKind RegardsSteve

Hi,we have LMS 2.5.1 on Solaris 9. Can i change the quantity of the Version that i can archived?ty

Hi,We are using CiscoWorks software to deploy new configuration to our network devices.  Because our environnement is mixed about version of network devices we have to create a new netconfig job for each device model, because in some plate-forme conf...

Hello,I need to install lms 1500 devices lic & HUM 1000 devices lic. as i read, i understand that i cannot install these two applicationes on the same server.my question is this,if i want to install the HUM in a standalone server, i need CiscoWorks C...