I need to make a EoGRE tunnel from a x86 linux PC to cisco ASR 1002x. I verified tunnel between PC's and similar approach followed with router.Following are the commands used in routerWAG(config)#interface Tunnel1%LINEPROTO-5-UPDOWN: Line protocol on...
Has anyone used the Webui to upgrade their Cisco Router Firmware? If so, how did it go? Any information would be greatly appreciated.
I have two C1000 that are h-stacked and using the Web UI to manage them. It all worked great, but when I bought a third switch I was unable to get it to join the others and when I plugged it in, the first two fell apart. The switches are handling tra...
On switch LS I create 10.0.0.1/8 on D2 I create 10.0.0.2/8 as part of a lab I accidentally type in 10.0.0.3 and it says bad mask (see out put below) I thought numbers went up to 255 so why is 10.0.0.3 a bad mask? Toplogy below: Output from the righ...
Hello, I have different printers that we need to be contacted from an outside IP range. They way I set it is through Port Forwarding, like this example:External Service (PRINTER4) / Internal Service (PRINT) / Internal IP Address (x.x.x.x) / Interface...
Hi,Im looking for a way to identify if a device is LLDP enabled, using SNMP. There's 2 scenarios in my case. 1. LLDP is enabled, but no neighbors are available(for some reasons)#show lldp neighborsCapability codes:(R) Router, (B) Bridge, (T) Telepho...
Hi,I have added some new APs to PI 3.7 and they are listed under Inventory>Device Management>Network Devices, but they do not show in Maps>Topology Maps>Network Topology. I have tried to add the APs to a group / site in Inventory>Device Management>N...
I have 3 Cisco switches connected daisy chain one to another to another. I have read that I can and I can not do this so I'll ask. Is there and advantage in using 2 patch cables between each switch? I've read it is suppose to increase performance. bu...
We have purchase APNIC IP pool and this IP pool configure in our DC servers, now we have to publish this IP pool through BGP, could someone please give idea to configure on cisco router end.
I am unable to log in to CISCO Any Connect. I have been using the same password for the last few years but suddenly from the last few days, I can't log in using the same. Is there any way to resolve the issue?
Hello, There’s a growing number of users who are experiencing network performance issue in one of our locations. They are getting disconnected at some point and reconnected after a couple of seconds. After analyzing log messages on the switch I’ve no...
Software Version - Cisco Prime 3.9.0.0.219 if i create a alarm policy to change the LINK DOWN alarm severity to minor (or any other ) which is Critical by default, Its not working properly all the time . its logs as minor sometime but,Prime still ale...
I'm attempting to connect to a Cisco 4010 network switch via it's built in usb port (which internally is a usb to rs232 adapter wired to the back of the console port).I have installed the Cisco usb console drivers version 3.1When I plug into the usb ...
Hello Everyone, We are using EEM to create several ups to our scp server. We would like to append something to the end of each file name so that the previous backup does not get overwritten. For example, here is what I am using on a 4431 router confi...
